User manual PHILIPS 231C5TJKFU/00

[. . . ] 3 Bortskaffelse af produkt og emballage Elskrot WEEE (Waste Electrical and Electronic (TXLSPHQW Taking back/Recycling Information for Customers Philips establishes technically and economically viable objectives to optimize the environmental performance of the organization's product, service and activities. From the planning, design and production stages, Philips emphasizes the important of making products that can easily be recycled. At Philips, end-of-life management primarily entails participation in national take-back initiatives and recycling programs whenever possible, preferably in cooperation with competitors, which recycle all materials (products and related packaging material) in accordance with all Environmental Laws and taking back program with the contractor company. [. . . ] 1 Strømindikator Tryk for at tænde og slukke for skærmen. Check for Update (Tjek for opdateringer), About (Om) og Exit (Afslut). ‡ Check for Update (Tjek for opdateringer) - leder brugeren til PDI Landing og tjekker brugerens version i forhold til den nyeste version. Lovmæssige oplysninger Lead-free Product Lead free display promotes environmentally sound recovery and disposal of waste from electrical and electronic equipment. Toxic substances like Lead has been eliminated and compliance with European community’s stringent RoHs directive mandating restrictions on hazardous substances in electrical and electronic equipment have been adhered to in order to make Philips monitors safe to use throughout its life cycle. EN 50581:2012 (Technical documentation for the assessment of electrical and electronic products with respect to the restriction of hazardous substances) 2006/95/EC (Low Voltage Directive). 1275/2008 and 642/2009 Implementing Directive for Standby and Off mode power consumption). Lovmæssige oplysninger )HGHUDO &RPPXQLFDWLRQV &RPPLVVLRQ )&& 1RWLFH 86 2QO\ This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ‡ ‡ ‡ Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. &KDQJHV RU PRGLÀFDWLRQV QRW H[SUHVVO\ approved by the party responsible for compliance could void the user's authority to operate the equipment. Use only RF shielded cable that was supplied with the monitor when connecting this monitor to a computer device. 7R SUHYHQW GDPDJH ZKLFK PD\ UHVXOW LQ ÀUH RU shock hazard, do not expose this appliance to rain or excessive moisture. [. . . ] Note The EU Energy Label will be ONLY applied on the models bundling with HDMI and TV tuners. Tætsiddende pixeldefekter Da pixel- og sub-pixeldefekter af samme type, der ligger tæt på hinanden, kan være PHUH L¡MQHIDOGHQGH VSHFLÀFHUHU 3KLOLSV RJVn tolerancer for tætsiddende pixeldefekter. ISO9241-307 is the successor of formerly known ISO13406 standard, which is withdrawn by the International Organisation for Standardisation (ISO) per: 2008-11-13. [. . . ]