User manual PHILIPS 26HF5443-28B

[. . . ] Normal use of the TV should involve the showing of pictures that contain constantly moving and changing images that fill the screen. Warning concerning VGA/HDMI display mode As this product processes in VGA/HDMI mode, some diagonal lines may be seen under circumstances of environmental interference. This will not affect the computer signal performance that displays in VGA/HDMI mode. environmental · Your television contains material that can be recycled and reused by specialized companies. [. . . ] Switch On/OSD : In this sub -menu the behavior of the TV after switching on and the behavior of the On Screen Display can be selected. Picture/Sound: In this sub-menu, the Picture and Sound settings of the TV can be selected. Security: In this sub-menu, the Security settings of the TV can be configured. Control: In this sub -menu, the Control settings of the TV can be configured. CC/V-Chip: In this sub-menu, the Close Caption and V-Chip settings of the TV can be configured. In this sub menu the behavior of the TV after switching on and the behavior of the On Screen Display can be selected. ⷠWelcome Message: Press Cursor Left/Right to display the Welcome message entry menu: o Welcome Message o Line 1 o Line 2 o Clear With the Cursor Up/Down buttons you can set the message characters. A specific channel or input can be set so the TV always comes on to that specific channel. If STANDARD is selected, the set will turn on to the volume at power off. A specific switch on volume can be set so the TV always comes on to that specific volume. A description of each of these formats can be found in the Picture Formats section. Power On: The Power On menu function defines the behavior of the television whenever AC Power is applied. the valid states are "FORCED ON" , "LAST STATUS" and "STANDBY". O When "FORCED ON", the television can only be switched OFF by means of the main switch or a setup remote control or by ESP function (Energy Saving Programmability controls the maximum continuous viewing time allowed by the control system). When AC is applied the television turns ON. O When "LAST STATUS", the television goes to the previous status, ON or Stand-by when AC is applied. O When "STANDBY", the television always goes to Stand-by when AC is applied. In this sub menu, the Picture and Sound settings of the TV can be configured. Contrast: This changes the difference between the light and dark tones. Sharpness: This changes the picture definition. Tint: Adjusts the picture to obtain natural skin tones. active Control: Active Control optimises the quality of the picture according to the quality of reception. [. . . ] For a two digit programme number, enter the second digit before the dash appears. + CH ­ Channel Selection To move up or down a TV channel. If the word "LOW" appears instead of "OK", the batteries are low and must be replaced. Should your remote be lost or broken you can still change some of the basic settings with the keys on top/side of your TV. [. . . ]