User manual PHILIPS 28PW9623

[. . . ] Information for users in the UK (Not applicable outside the UK) Positioning the TV For the best results, choose a position where light does not fall directly on the screen, and at some distance away from radiators or other sources of heat. Leave a space of at least 5 cm all around the TV for ventilation, making sure that curtains, cupboards etc. cannot obstruct the air flow through the ventilation apertures. The TV is intended for use in a domestic environment only and should never be operated or stored in excessively hot or humid atmospheres. General Points Please take note of the section 'Tips' at the end of the English section in this booklet. [. . . ] The sound style is set to Manual until the personal graphic equalizer settings are stored and you have switched your TV off and on again. Switch Loudness on or off When Loudness On is selected, the low and high frequencies are amplified so that the natural balance is restored when listening at a low volume. The selected setting for Loudness is stored for all TV channels. Headphone See Connect Peripheral Equipment, p. Select Dual to choose between the dubbed or original language when the TV channel broadcasts in two languages. Headphone Volume J Dual (Dual) · To exit from the menus Press the corresponding red, green or yellow colour key. 13 Dolby* Pro Logic SOUND J Dolby Pro Logic Volume Graphic Equalizer Loudness Headphone Adjust the volume balance level of the loudspeakers Most programmes will sound good with the volume balance between the centre left and right and rear loudspeakers in an equally loud position. However, some programmes may benefit from an adjustment of the level of the respective speakers. Which loudspeakers are active depends on the Surround Mode selection you make below. & Select Pro Logic in Surround Mode of the DOLBY PRO LOGIC menu. Dolby Pro Logic Left Centre Rear Rear Right é Select Start Test and press the OK key in the centre of the cursor. A steady noise tone is switched sequentially through the left, centre, right and rear loudspeakers, for 2 seconds each. This enables you to adjust the volume of the separate loudspeakers. The loudspeakers activated light up in the on screen graphic. " Select Centre Volume, Balance or Rear Volume and alter the selected adjustments. ` Select Stop Test in the DOLBY PRO LOGIC menu and press the OK key when you have finished the adjustments of the level of the speakers. Surround mode Select the Dolby Surround Sound mode according to the sound mode being broadcast. When no Surround Sound is available (Dolby 3 Stereo or Off) the wireless surround loudspeakers are switched to standby after about 15 seconds. Pro Logic (with Dolby Surround broadcasting) In addition to the left and right front speakers, the centre and the rear surround loudspeakers reproduce the Dolby Surround Pro Logic sounds. This 4-channel sound is always recorded when the movie or programme is marked with Dolby Surround. This mode is especially recommended for such programmes as movies. Dolby 3 Stereo (with Dolby Surround broadcasting) The Dolby 3 Stereo sound signal is now distributed over the front left, the front right and the centre loudspeakers. The rear loudspeakers do not produce any signal. J Start Test Stop Test Centre Volume Balance Rear Volume Surround Mode Pro Logic Dolby 3 Stereo Hall (with Dolby Surround broadcasting) The centre sound signal is distributed over the rear loudspeakers which creates a hall effect from the rear. The centre loudspeaker does not produce any signal. This mode is recommended when you wish to add surround sound to a broadcast which is not encoded Dolby Surround. [. . . ] In 100 Hertz sets, the picture area is scanned at a rate of 100 times per second (100 Hertz). At this frequency, the eye cannot detect flicker, resulting in a clearer picture which is more relaxing to the eye. Automatic Channel Installation (ACI) Automatically installs all TV channels in the same order as offered by your cable company, provided of course that the data is transmitted. It also automatically includes programme number and programme name. [. . . ]