User manual PHILIPS 29PT8422 Quick Start

[. . . ] AUTO PICTURE Button - Press repeatedly to choose from 5 different factory predefined picture settings. Choose from Personal (how you set the Picture Menu Adjustment controls), Movies (for movies), Sports (for any sporting event), Weak Signal (used when the signal being received is not great), or Multimedia (for video games). These buttons can also be used with a VCR when the TV/VCR/ACC Switch is in the VCR position. Press Play q, Stop u, s Rewinds, or Fast Forward r, Also, you can use the CURSOR UP q or CURSOR DOWN u to activate or deactivate the screen formatting control. [. . . ] After using the AutoProgram Control, press the CH + and ­ buttons to scroll through all the channels stored in the television's memory. Signal Iforyourtocablefollowtheuses a cable box decoder, the easy steps below complete connection. Using a separate round coaxial cable, connect one end to the OUT(put) (TO TV) plug on the back of the Cable Box. Connect the other end of the round coaxial cable to the 75 ohm input on the back of the television. NOTE: If applicable, set the OUTPUT CHANNEL SWITCH on the back of the cable box to CH 3 or 4. tune the TV to the same channel and change channels at the cable box. In some cases, the cable box will automatically tune to either channel 3 or 4, change channels until the picture appears. Using a RCA type Video Cable, connect one end of the cable to the Video (or ANT, your cable box may be labeled differently) Out jack on the cable box and the other end to the AV1 Video Input on the TV. Once tuned, change channels at the cable box, not the television. Cable Box with A/V Outputs Cable Signal IN from the Cable Company He TV's audio/video input jacks are for direct picture and sound connections between the TV and a VCR (or similar device) that has audio/video output jacks. Both the AV1 and AV2 Input Jack connections are shown on this page, but either one can be connected alone. Follow the easy steps below to connect your accessory device to the AV1 and AV2 IN Jacks located on the back of the TV. Connect the VIDEO (yellow) cable to the VIDEO OUT jack on the back of the VCR (either one or two) or accessory device being used. Audio and video cables are not supplied with the TV, but are available from Philips or electronics retailers. He S(uper)-Video connection on the rear of the TV can provide you with better picture detail and clarity for the playback of accessory sources such as DBS (digital broadcast satellite), DVD (digital video discs), video games, and S-VHS VCR (video cassette recorder) tapes than the normal antenna picture connections. NOTE: The accessory device must have an S-VIDEO OUT(put) jack in order for you to complete the connection on this page. Then connect one end the AUDIO (red and white) CABLES to the AV1 in AUDIO L and R (left and right) jacks on the back of the TV. Connect other end of the S-VIDEO CABLE to the S-VHS (S-Video) OUT jack on the back of the VCR. Then connect the other ends of the AUDIO (red and white) CABLES to the AUDIO (left and right) OUT jacks on the rear of the VCR. Press the CH + or CH ­ buttons on the remote to scroll the channels until AV2 appears in the upper left corner of the TV screen. When a Component Video Device is connected as described, it is best not to have a video signal connected to the AV1 in Video Input jack. Back of digital signal source material, such as with DVD players. [. . . ] cable Connect one end of the yellow Video Cable to the Monitor Out VIDEO plug. Connect the other end to the VIDEO IN plug Audio on the second VCR. Cables Connect one end of the red and white Audio cable from the Monitor Out AUDIO L and R plugs on the TV to the AUDIO IN plugs on the VCR. Turn the Second VCR ON, insert a VHS tape and it's 1st VCR ready to record what's being (refer to page 6 for viewed on the TV screen. [. . . ]