User manual PHILIPS 30 IN WIDESCREEN HDTV MONITOR 30PW862H

[. . . ] . 8 IMPORTANT NOTE: This owner's manual is used with several different television models. Not all features (and drawings) discussed in this manual will necessarily match those found with your television set. This is normal and does not require that you contact your dealer or request service. WARNING: TO PREVENT FIRE OR SHOCK HAZARD DO NOT EXPOSE THIS UNIT TO RAIN OR EXCESSIVE MOISTURE. BASIC TV OPERATION Y our television has a set of controls located on the top and front of the cabinet for use when the remote control is not needed. Press the POWER button on the front of the TV cabinet to turn the TV ON. [. . . ] The current channel will be highlighted as default. Five channels will be listed on screen at one time. Press the Cursor Ring up or down to scroll the list and and highlight a channel. Press the Cursor Ring right to tune to the highlighted channel. Channels marked "Skipped" in the Channel Edit control will not appear in the list. Each channel that is being blocked by AutoLockTM will appear with a padlock icon to indicate that the channel is not viewable. Rec ¶ - Press this button simultaneously with the 3 button when in VCR mode to record. Dolby V - Press to select various factory surround SAP - When in the TV mode, press to select between main sound and SAP (Second Audio Program) when you tune to a program offering SAP. AV - Press repeatedly to select the different signal sources connected to the TV: TV (current channel), AV1, CVI, AV2, AV3 (side jack panel), AV4 and AV5. Clock - Press to access the onscreen Timer menu, where you can set the time for the TV's clock or set the TV's Timer features, such as channel switch over, power on set, and power off set. Position - Press to move the PIP picture to any of the four corners of the screen. sound listening modes. Dolby* Virtual (Virtual Dolby Surround) (with Virtual Dolby Surround signals) - Dolby Virtual uses two speakers to simulate the surround effect produced by a multichannel system. Incredible SurroundTM - In Stereo sound mode--when Incredible SurroundTM is turned on-- it seems as though the loudspeakers are spread farther apart from each another. In Mono sound mode--when Incredible SurroundTM is turned on-- enables you to hear a spatial sound effect. PIP - Press to turn PIP (picture-in-picture) on or off or control the size of the PIP window. Back Light button - Press to light the buttons on the remote control. 2 HOOKING UP DIRECT CABLE TV INPUT THE TELEVISION AC Power Wall Outlet HD1 HD2 Direct Cable Connection: Cable signal coming from Cable Company (Round 75 coaxial cable) Y our Cable TV input into your home may be a single (75 ohm) cable or a converter box installation. In either case, the connection to the TV is very easy. Turn the VCR (accessory device) and the TV ON. Press the AV button on the remote control to tune to the AV2 channel. Insert a prerecorded tape (or CD, DVD, depending on the type of accessory device being used) and, press the PLAY button on the accessory device to view the playback. S-VIDEO OUT 2 1 ANT/CABLE OUT R L AUDIO OUT VIDEO OUT FIRST VCR CONNECTED TO AV1 INPUTS 6 VIDEO IN (YELLOW) AUDIO IN (RED/WHITE) ANT/CABLE OUT S-VIDEO OUT R L AUDIO OUT VIDEO OUT 4 5 4 BACK OF 2ND VCR 3 7 SECOND VCR or ACCESSORY DEVICE (EQUIPPED WITH VIDEO AND AUDIO OUTPUT JACKS) HOOKING UP USING THE THE TELEVISION AV 5 INPUT JACKS Note: If the AV5 channel is tuned and no signal connection present, the screen could jump or flash. T he AV5 Input Jacks provide High Definition Video Inputs at 1080i or 480p, for accessories like a HD Receiver and Digital DVD Players. There is also a DVI jack supplied allowing encrypted transmission of uncompressed HD content. Connect the Component (Y, Pb, Pr) Video OUT jacks from the HD accessory device to the (Y, Pb, Pr) AV5 IN(put) jacks on the TV. If the device your using is equipped with separate Horizontal and Vertical sync, connect the H and V Outputs on the accessory device to the H and V Inputs of AV5 IN. Connect the red and white AUDIO CABLES to the Audio (left and right) output jacks on the rear of the HD accessory device to the Audio (L and R) AV5 IN(put) jacks on the TV. Connect a DVI cable from the DVI OUT on the HD accessory device to the AV5 DVI jack on the back of the TV. Connect a 75 round cable from the OUT TO TV jack on the HD accessory device to the 75 IN on the back of the TV. If using a Satellite Dish, Cable signal or Antenna signal, connect the 75 round cable from a Satellite Dish to the SATELLITE IN and/or the Cable and Antenna signals to the ANTENNA "A" or "B" IN on the back of the HD accessory device. Press the AV button on the remote control repeatedly to tune to the AV5 channel. HORIZONTAL AND VERTICAL SYNC CABLES 1 HD1 HD2 JACK PANEL ON BACK OF TV 1 2 3 4 5 6 2 AUDIO IN (RED/WHITE) COMPONENT VIDEO CABLES DVI CABLE 3 4 1 Y Pb Pr COMPONENT VIDEO H SYNC OUT V BACK of ACCESSORY DEVICE 2 L L VIDEO S-VIDEO R R DIGITAL AUDIO OUTPUT VCR CONTROL AUDIO 5 ANTENNA A IN SATELLITE IN OUT TO TV PHONE JACK ANTENNA B IN Your now ready to use your digital device to begin playback of high definition quality. COAXIAL CABLE LEAD-IN FROM SATELLITE DISH 5 AV5 COAXIAL CABLE LEAD-IN FROM ALTERNATE RF SIGNAL SOURCE 5 COAXIAL CABLE LEAD-IN FROM CABLE OUTLET, CONVERTER BOX, OR VHF/UHF ANTENNA NOTE: This television is designed to accept high definition signals 1080i and 480p as specified by the Electronic Industries Association standard EIA770. 3. [. . . ] Turn the TV and the DVD (or digital accessory device) ON. Insert a DVD disc into the DVD player and press the PLAY button on the DVD Player (or digital accessory device). Y 1 2 COMPONENT VIDEO CABLES COMP VIDEO Pb OUT Pr OUT S-VIDEO VIDEO AUDIO IN (RED/WHITE) AUDIO R OUT L HELPFUL HINT The description for the component video connectors may differ depending on the DVD player or accessory digital source equipment used (for example, Y, Pb, Pr; Y, B-Y, R-Y; Y, Cr, Cb). Although abbreviations and terms may vary, the letters b and r stand for the blue and red color component signal connectors, and Y indicates the luminance signal. Refer to your DVD or digital accessory owner's manual for definitions and connection details. 1 3 4 ACCESSORY DEVICE EQUIPPED WITH COMPONENT VIDEO OUTPUTS. VIDEO (YELLOW) CABLE 2 5 JACK PANEL ON BACK OF TV S-VIDEO INPUT T he S(uper)-Video connection on the rear of the TV can provide you with better picture detail and clarity for the playback of accessory sources such as DBS (digital broadcast satellite), DVD (digital video discs), video games, and S-VHS VCR (video cassette recorder) tapes than the normal antenna picture connections. [. . . ]