User manual PHILIPS 30-HDTV MONITOR WIDESCREEN TV 30PW8402

[. . . ] cH(annel) + or CH(annel)- Buttons - Press to select channels in ascending or descending order. SLEEP BUTTON - Press the SLEEP button to set the the TV to automatically turn itself off after a set period of time. The picture will freeze on the screen until the Play or Pause buttons are pressed again. NUMBERED (0-9) Buttons - Press the numbered buttons to select TV channels or to enter certain values within the on-screen menu. [. . . ] Point the remote control toward the remote sensor window on the TV when operating the TV with the remote. O load the supplied batteries into the remote: Be sure the (+) and (-) ends of the batteries line up correctly (inside of case is marked. Input come from a single (75 ohm) round Your home's signalfrom anmight cable, Antenna Connection a Converter Box, or antenna. In either case the connection to the TV is very easy. If your Cable TV signal or Antenna signal is a round cable (75 ohm) then you're ready to connect to the TV. If your antenna has flat twinlead wire (300 ohm), you first need to attach the antenna wires to the screws on a 300 to 75 ohm adapter. If you have a Cable Converter Box: Connect the OUT(put) plug from the Converter to the 75 ohm plug on the TV. Our Cable TV input into your Direct Cable Connection home may be a single (75 ohm) cable or use a cable box decoder. In either case the connection is very Cable signal simple. Follow the steps below to coming from connect your cable signal to your Cable Company new television. This connection will supply Stereo sound to the TV. The color difference signals (Pb, Pr) and the luminance (Y) signal are connected and received separately, which allows for improved color bandwidth information (not possible when using composite video or S-Video connections). Connect the Component (Y, Pb, Pr) Video OUT jacks from the DVD player (or similar device) to the (Y, Pb, Pr) in(put) jack on the TV. When using the Component Video Inputs, it is best not to connect a signal to the AV in Video Jack. Press the CH + or CH ­ buttons to scroll the available channels until CVI appears in the upper left corner of the TV screen. Insert a DVD disc into the DVD player and press the PLAY button on the DVD Player. The description for the component video connectors may differ depending on the DVD player or accessory digital source equipment used (for example, Y, Pb, Pr; Y, B-Y, R-Y; Y, Cr, Cb). Although abbreviations and terms may vary, the letters b and r stand for the blue and red color component signal connectors, and Y indicates the luminance signal. Connect an HD Receiver to the HDMI Input: Please refer to your Receiver's Owner's Manual for more detailed hookup options. If using a Satellite Dish, Cable signal or Antenna signal, connect the 75 ohm round cable from a Satellite Dish to the SATELLITE IN and/or the Cable and Antenna signals to the ANTENNA "A" or "B" IN on the back of the HD Receiver. Connect another 75 ohm round cable from the OUT TO TV jack on the HD Receiver to the 75 ohm IN on the back of the TV. Connect a HDMI cable from the DVI OUT on the HD Receiver to the HDMI Input jack on the back of the TV. [. . . ] To adjust the volume on the audio system, you will need to change the volume at the external audio system, not the television. SECOND VCR CONNECTION: Audio Cables NOTE: Refer to panel number 6 for (Red and White) the proper hookup of the first VCR. Follow the instructions on how to SECOND VCR CONNECTION: tune to the AV1 channel to view a pre-recorded tape. Back of TV The following steps allow you to connect a second VCR to record the program while your watching Video it. [. . . ]