User manual PHILIPS 30188-11-16

[. . . ] These differences depend on the brand and model of your device. Also, this remote control can only operate features that exist on your device. The RECORD (0) button must be pressed twice to record. For some brands of DVRs, you might need to press the RECORD (0) once, then press it again for three seconds. [. . . ] for example: you can store a DVR code under the CBL button , or a DVD code under the DVR button , etc. However, you can only store TV codes under the TV button. Then follow the steps for `Code search by brand' (chapter 3. If the device does not have a CH + button, use the PLAY (2) - DVR only - or POWER (y) button instead. Code Search starts from the currently stored 4 digit number under that mode. For Combo Devices, in many cases a single code operates both parts of the device (e. In other cases you need to set up two codes. For example, if you have a TV / DVD combo, you need to set up one code under the TV button to control the TV part and a separate code (under any other Mode button) to control the DVD part. When setting the remote control up for your devices, the remote control copies the Volume / Mute settings as follows: · If a device has its own Volume / Mute buttons in the remote control database, then these buttons will be used. You can set all devices to use the Volume / Mute buttons of a single device without needing to change to that device mode. 1 Press and hold the SETUP button until the red light indicator turns on, then release the button. The red light indicator flashes, then remains lit. Press and release the button on the SRU5107 that you wish to learn a new function (e. Point both remote controls facing each other by approximately 1 inch apart (refer to chapter 5. Press and hold the button from which you wish to learn on the original remote control (e. POWER) until the red light indicator flashes once and then remains lit. If there is a learning problem, the red light indicator flashes for three seconds and then remains lit. Repeat steps 4 to 6 for other buttons you wish to learn a new function. Press and release the SETUP button when all desired remote control commands have been learned. Clearing learned commands can be useful if, for example, you replace your CD player with another brand or model. If you had learned a feature from your old CD player's original remote control on to this remote control (such as RANDOM PLAY), that feature would no longer work for your new CD player. 1 Press and hold the SETUP button until the red light indicator turns on, then release the button. [. . . ] Avoid learning your original remote control DVR control buttons unless you are sure these operate the same device e. Some original TV remote controls include DVR button control and can have two different types of code. If you have continual problems learning from your original remote control, try clearing all learned commands as described in chapter 5. This remote control operates the common features of most but not all models and brands of IR (Infrared) controlled Audio / Video equipment. [. . . ]