User manual PHILIPS 32-SILVER-CUSTBUILTTV STAND-GLASS DOORS PH321RFS01

[. . . ] Consult a service technician if the monitor does not operate normally when you have followed the instructions in this manual. The casing cover should be opened only by qualified service personnel. Keep the monitor out of direct sunlight and away from stoves or any other heat source. Remove any object that could fall into the vents or prevent proper cooling of the monitor's electronics. [. . . ] In this case, try manually adjusting your pictures: see 'fine tuning' or adjust the direction of the outside aerial. q No TV picture No picture when TV input was selected Have you connected the aerial socket properly?Poorly connected SCART cables or aerial sockets are often the cause of picture or sound problems (sometimes the connectors can become half disconnected if the LCD Monitor TV set is moved or turned). Check all connections. q No sound No sound output when a program with sound was playing q Ensure that the audio cables are firmly connected to both the audio input connectors on your the LCD Monitor TV and audio output connectors on your PC or Video player. If on certain TV channels you receive a picture but no sound, this means that you do not have the correct TV system. Modify the SYSTEM setting. Video Problems Check Video Input Selection r Composite: Yellow colored RCA jack r S-Video: Typically a round 4 pin jack r Component: Typically 3 RCA jacks of Green, Red and Blue. Make sure you did not plug the video cable to video output port behind the LCD monitor TV. q No Video No signal indicator is displayed. q Low Quality DVD playback Picture not crisp and some color distortion q Check DVD connection r Composite gives good picture r S-Video gives better picture r Component gives best picture file:///D|/My%20Documents/dfu/BDL3221V/english/320wn6/SAFETY/saf_troub. htm (4 of 7)2005-11-07 12:52:12 PM Troubleshooting q No sound See video but no audio q q q Check if the LCD Monitor TV volume is turn off of muted. Verify that the audio source is selected correctly in the OSD. Remote Control Problems Remote control does not work properly No response from the LCD Monitor TV when remote is pressed Point the remote control directly at the remote sensor on the LCD Monitor TV. Make sure the remote control is not disabled (for disable/enable the remote control, please refer to the section of Remote Control). q q q Product Specific Problems Screen image is too small Image is centered on screen, but does not fill entire viewing area Perform the LCD Monitor TV factory reset (via Menu -> Factory Reset -> All Settings). q Cannot adjust the LCD Monitor TV with the buttons at the side of the unit OSD does not appear on the screen q Turn the LCD Monitor TV off and unplug the power cord and then plug back and power on. For further assistance, refer to the Consumer Information Centers list and contact your local Philips distributor. RETURN TO TOP OF THE PAGE OSD Warning Messages A warning message may appear on the screen indicating the LCD Monitor TV current status. file:///D|/My%20Documents/dfu/BDL3221V/english/320wn6/SAFETY/saf_troub. htm (5 of 7)2005-11-07 12:52:12 PM Troubleshooting When user sees this warning message, it means that the LCD Monitor TV is in adjustment process. A warning message may appear on the screen indicating that the LCD Monitor TV is out of sync range. See Specifications for the Horizontal and Vertical frequency ranges addressable by this the LCD Monitor TV. Recommended mode is 1360 x 768 @ 60Hz. This message means that there is no video input signal. The LCD Monitor TV is in a power saving mode (in PC mode). The main OSD menu is unlocked. The main OSD menu is locked. file:///D|/My%20Documents/dfu/BDL3221V/english/320wn6/SAFETY/saf_troub. htm (6 of 7)2005-11-07 12:52:12 PM Troubleshooting RETURN TO TOP OF THE PAGE file:///D|/My%20Documents/dfu/BDL3221V/english/320wn6/SAFETY/saf_troub. htm (7 of 7)2005-11-07 12:52:12 PM Regulatory Information Regulatory Information CE Declaration of Conformity · Display Power Management Signaling · Federal Communications Commission (FCC) Notice (U. S. Toutes modifications n'ayant pas reçu l'approbation des services compétents en matière de conformité est susceptible d'interdire à l'utilisateur l'usage du présent équipement. N'utiliser que des câbles RF armés pour les connections avec des ordinateurs ou périphériques. CET APPAREIL NUMERIQUE DE LA CLASSE B RESPECTE TOUTES LES EXIGENCES DU REGLEMENT SUR LE MATERIEL BROUILLEUR DU CANADA. RETURN TO TOP OF THE PAGE EN 55022 Compliance (Czech Republic Only) file:///D|/My%20Documents/dfu/BDL3221V/english/320wn6/SAFETY/REGS/REGULAT. HTM (4 of 11)2005-11-07 12:52:14 PM Regulatory Information RETURN TO TOP OF THE PAGE VCCI Notice (Japan Only) This is a Class B product based on the standard of the Voluntary Control Council for Interference (VCCI) for Information technology equipment. If this equipment is used near a radio or television receiver in a domestic environment, it may cause radio Interference. Install and use the equipment according to the instruction manual. Class B ITE RETURN TO TOP OF THE PAGE MIC Notice (South Korea Only) Class B Device file:///D|/My%20Documents/dfu/BDL3221V/english/320wn6/SAFETY/REGS/REGULAT. HTM (5 of 11)2005-11-07 12:52:14 PM Regulatory Information Please note that this device has been approved for non-business purposes and may be used in any environment, including residential areas. RETURN TO TOP OF THE PAGE Polish Center for Testing and Certification Notice The equipment should draw power from a socket with an attached protection circuit (a three-prong socket). All equipment that works together (computer, monitor, printer, and so on) should have the same power supply source. The phasing conductor of the room's electrical installation should have a reserve short-circuit protection device in the form of a fuse with a nominal value no larger than 16 amperes (A). To completely switch off the equipment, the power supply cable must be removed from the power supply socket, which should be located near the equipment and easily accessible. A protection mark "B" confirms that the equipment is in compliance with the protection usage requirements of standards PN-93/T-42107 and PN-89/E-06251. file:///D|/My%20Documents/dfu/BDL3221V/english/320wn6/SAFETY/REGS/REGULAT. HTM (6 of 11)2005-11-07 12:52:14 PM Regulatory Information RETURN TO TOP OF THE PAGE North Europe (Nordic Countries) Information Placering/Ventilation VARNING: FÖRSÄKRA DIG OM ATT HUVUDBRYTARE OCH UTTAG ÄR LÄTÅTKOMLIGA, NÄR DU STÄLLER DIN UTRUSTNING PÅPLATS. Placering/Ventilation ADVARSEL: SØRG VED PLACERINGEN FOR, AT NETLEDNINGENS STIK OG STIKKONTAKT ER NEMT TILGÆNGELIGE. Paikka/Ilmankierto VAROITUS: SIJOITA LAITE SITEN, ETTÄ VERKKOJOHTO VOIDAAN TARVITTAESSA HELPOSTI IRROTTAA PISTORASIASTA. Plassering/Ventilasjon ADVARSEL: NÅR DETTE UTSTYRET PLASSERES, MÅ DU PASSE PÅ AT KONTAKTENE FOR STØMTILFØRSEL ER LETTE Å NÅ. file:///D|/My%20Documents/dfu/BDL3221V/english/320wn6/SAFETY/REGS/REGULAT. HTM (7 of 11)2005-11-07 12:52:14 PM Regulatory Information RETURN TO TOP OF THE PAGE BSMI Notice (Taiwan Only) RETURN TO TOP OF THE PAGE Ergonomie Hinweis (nur Deutschland) Damit Ihr Monitor immer den in der Zulassung geforderten Werten entspricht, ist darauf zu achten, daß 1. Reparaturen nur durch Fachpersonal durchgeführt werden. nur original-Ersatzteile verwendet werden. bei Ersatz der Bildröhre nur eine bauartgleiche eingebaut wird. Aus ergonomischen Gründen wird empfohlen, die Grundfarben Blau und Rot nicht auf dunklem Untergrund zu verwenden (schlechte Lesbarkeit und erhöhte Augenbelastung bei zu geringem Zeichenkontrast wären die Folge). [. . . ] Yukari Dudullu Org. San. Bolgesi 2. Cadde No:22 34776-Umraniye/Istanbul Tel: (0800)-261 33 02 UKRAINE Comel Shevchenko street 32 UA - 49030 Dnepropetrovsk Tel: +380 562320045 www. csp-comel. com Latin America ANTILLES Philips Antillana N. V. box 3523-3051 Willemstad, Curacao Phone: (09)-4612799 Fax : (09)-4612772 ARGENTINA Philips Antillana N. V. Vedia 3892 Capital Federal CP: 1430 Buenos Aires Phone/Fax: (011)-4544 2047 BRASIL Philips da Amazônia Ind. Rua Verbo Divino, 1400-São Paulo-SP CEP-04719-002 Phones: 11 21210203 -São Paulo & 0800-701-0203-Other Regions without São Paulo City file:///D|/My%20Documents/dfu/BDL3221V/english/warranty/warcic. htm (4 of 11)2005-11-07 12:52:59 PM Consumer Information Centers CHILE Philips Chilena S. A. [. . . ]