User manual PHILIPS 3200 SERIES EP3249

[. . . ] Removing and inserting the brew group ____________________________________________________________ A1 Control panel A2 Cup holder A3 Pre-ground coffee compartment A4 Lid of bean hopper A5 Adjustable coffee spout A6 Mains plug A10 Service door A11 Data label with type number A12 Water tank A13 Hot water spout A14 Coffee grounds container A15 Front panel of coffee grounds Refer to figure B for an overview of all buttons and icons. Some of the buttons/icons are for specific types only. Congratulations on your purchase of a Philips fully automatic coffee machine!To fully benefit from the support that Philips offers, please register your product at www. [. . . ] If you don't do this, air might be drawn into the machine instead of water, which makes a lot of noise and prevents the machine from being able to brew coffee. 1 Make sure that the machine is switched on. 2 Shake the filter for about 5 seconds (Fig. 3 Immerse the filter upside down in a jug with cold water and shake/press it (Fig. 4 The filter is now prepared for use and can be inserted into the water tank. 5 Insert the filter vertically onto the filter connection in the water tank. Press it down to the lowest 6 Fill the water tank with fresh water and place it back into the machine. 9 Press the AquaClean icon for 3 seconds (Fig. 10 Press the start/stop button to start the activation process. 12 When the activation process is finished, the blue AquaClean light goes on to confirm that the After 95 liters of water have flowed through the filter, the filter will cease to work. The AquaClean light turns orange and starts to flash to remind you to replace the filter. As long as it flashes, you can replace the filter without having to descale the machine first. If you do not replace the AquaClean water filter, the orange light will go out eventually. In that case you can still replace the filter but you first need to descale the machine. When the orange AquaClean light flashes: 1 Take out the old AquaClean water filter. 2 Install a new filter and activate it as described in chapter 'Activating the AquaClean water filter (5 Replace the AquaClean water filter at least every 3 months, even if the machine does not yet indicate that replacement is required. If you do not want to use Philips AquaClean water filters anymore, you can always deactivate the AquaClean reminders (AquaClean light flashing orange): 1 Press the on/off button to switch off the machine. 2 When the machine is switched off, press and hold the AquaClean icon until the light in this icon goes on. 3 Tap the AquaClean icon again to deactivate the reminders. The light in the AquaClean icon goes off. 4 Press the start/stop button to confirm your choice. 5 Press the on/off button to switch on the machine again. [. . . ] For at du kan komme i gang og få mest muligt ud af din maskine, tilbyder Philips support på flere forskellige måder. For at undgå lækage skal du sørge for, at rammen og mælkebeholderen er samlet korrekt, inden du fylder mælkebeholderen. - Indikatoren for kaffemængde lyser og viser den senest valgte drink-indstilling for varmt vand. 3 Tryk på ikonet for aromastyrke for at vælge den ønskede standbytid: 15, 30, 60 eller 180 minutter. [. . . ]