User manual PHILIPS 32HFL4007N

[. . . ] Provides superior picture quality by separating the green, blue and red luminance signals. Supplies a better picture than RF and Composite connections. Separate video (yellow) and audio (red/white) cables that provide a basic connection from the cable box and other devices. Com/usasupport today to get the very most from your purchase. [. . . ] When Autoprogramming is complete, a message appears confirming the completion. On timer (applicable for off-air channels only) From standby, this automatically switches the TV to the specified channel number, at a specified time. ( Select Channel and then the TV channel you want your TV to switch to on a selected time and day. § Select Day and then a day of the week or select Daily. è Select Time and enter the time with the digit keys or with the cursor up/ down. ç Press the cursor left to return to the Features menu or press the MENU key to switch off the menu. When you have locked TV channels while initiating autoprogram, a message appears asking to enter your PIN code in order to complete autoprogramming. When interrupted, the updated channel information is retained as well as the not yet updated old channel information. Background autoprogramming occurs only when the TV is turned on. If an NTSC channel is tuned, then in Background Autoprogramming the TV shall scan all the possible ATSC frequencies and update information. Weak channel installation : This allows you to manually tune weak ATSC channels in order to adjust the antenna and thus optimize signal quality for that channel. Note : Uninstalled channels are not reinstalled during an installation update. é Select Installation with the cursor down and press the cursor right to select Location This allows you to select the location of your TV. If you choose for Shop it will result in fixed settings of picture and sound. The location Home will give full flexibility to change any predefined settings for picture and sound. Notes: - You always have the possibility to remove the message from the screen. - The message display will overlap whatever menu element or other message is on the screen. - Always, when you always want the Emergency alert messages to be displayed when available; - Skip low priority, when you want the messages with low level to be ignored; - Skip low/medium priority, when you only want the messages with high priority to be displayed. Note: Emergency Alert Signalling is not possible: - when content browsing; - with analogue video sources. Show emergency alerts (EAS) This allows you to select the alert priority level of the information disseminated by the cable operator. the standard SCTE18 defines an Emergency Alert signalling method for use by cable TV systems to signal emergencies to digital devices such as digital set-top boxes , digital TVs and digital VCRs. The Emergency alert signalling scheme defined in the standard allows a cable operator to disseminate emergency alert information related to state and local-level emergencies and warnings in a cost-effective and efficient way, while minimizing disruption of programming. [. . . ] LOCAL KEYBOARD LOCKED ON The television keys VOLUME +/- , CHANNEL +/- and MENU are blocked. Channel information) OFF Screen information is suppressed (except for some VGA input, if present) SWITCH ON VOLUME When the user switches the TV ON, it will play at the specified volume level. note: "SWITCH ON VOLUME" cannot exceed the MAXIMUM VOLUME level. Whenever the BDS Mode Setup menu is accessed, the current volume level is reset to the SWITCH ON VOLUME level. [. . . ]