User manual PHILIPS 32PW9788

[. . . ] tv Laser Safety This unit employs a laser. Due to possible eye injury, only a qualified service person should remove the cover or attempt to service this device. USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. CLASS 1 LASER PRODUCT LASER Type Wave length Output Power Beam divergence Semiconductor laser InGaAIP 650 nm (DVD) 790 nm (VCD/CD) 7 mW (DVD) 5 mW (VCD/CD) DVD: Parallel: 8 degree Perpendicular: 28 degree CD: Parallel: 11 degree Perpendicular: 35 degree Information for users in the UK (Not applicable outside the UK) Positioning the TV For the best results, choose a position where light does not fall directly on the screen, and at some distance away from radiators or other sources of heat. Leave a space of at least 5 cm all around the TV for ventilation, making sure that curtains, cupboards etc. [. . . ] 15 Dual screen / PIP / Multipip Press the b key to switch on Dual screen, PIP or one of the PIP modes. Press the b key again. The screen that has a yellow border will become the full main screen picture. Notes: - Continuing to hold the b key down will cycle the TV through the various formats launching a new format after each second the key is held down. After standby of the TV, the preference as set in the Setup, General menu is used. - When Dual screen mode is selected, two picture formats are supported: Full screen or 4:3 letterbox picture format (vertical squeeze). - Audio from the right screen or the PIP plays to the headphones. - Dual screen/PIP/Multipip is not possible in Radio and DVD mode. Display options + V ¬ + B VCR DVD SAT AMP CD v ® Select Ì Ò æ ® b ® OK ® ® S º MENU P - Dual screen AUX PIP AUX PIP 3 PIP1 PIP2 PIP3 PIP1 PIP5 PIP9 PIP 12 PIP2 PIP6 PIP3 PIP7 PIP4 PIP8 1 4 7 i 2 5 8 0 Active Control 3 6 9 T/C PIP10 PIP11 PIP12 0 b b U DVD RADIO h Q q · Press the cursor right to highlight the right screen. · Press the cursor down to highlight the single PIP screen. · Press the cursor right to enter the Multipip screen and then use the cursor keys to navigate through the PIP screens and to hightlight a PIP screen. Changing TV channels or external sources in left, right, PIP or Multipip screen · Press the -P+ keys or the 0 key or the digit keys in order to change the TV channels or external sources in the highlighted screen. Scan PIP3 or PIP 12 Navigate to the lowest PIP and press the cursor down to display a following series of PIP screens. Define the position and the size of the single PIP screen & Select a Dual screen mode with a single PIP screen. é Press the cursor down to highlight the PIP screen. A PIP menu DISC MENU PLAYER SET UP LCD o oe Position Size " ` ( § è ! appears with which you can define the position and the size of the PIP screen. Note: When the PIP menu times out, press the OK key to make it reappear. Press the cursor down again to select Position or Size. Press the OK key or the cursor right to activate. Use the cursor keys to define the position of the PIP screen. Use the cursor left/right to define the size of the PIP screen. Press the OK key. The PIP menu reappears. Press the cursor up to the top of the menu to highlight the main screen again. [. . . ] Power consumption: 1 W. 3104 315 2218. 2 32 Table of TV frequencies. Liste des fréquences des émetteurs. Tabella delle frequenze delle trasmittenti. Lista de las frecuencias de las emisoras. [. . . ]