User manual PHILIPS 33614-17-16

[. . . ] · Electromagnetic compatibility (EMC) - Part. 3^ Limits - Section 2 : Limits for harmonic current emissions (equipment input current 16A for phase) EN 61000-3-2 (2006) · Electromagnetic compatibility (EMC) - Part 3^ : Limits - Section 3 : Limitation of voltage changes , voltage fluctuations and flicker in public low - voltage supply systems , for equipment with rated current 16 A for phase and not subject to conditional connection EN 61000-3-3 (1995)+ corr. (1997) +A1 (2001) + A2 (2005). · Electromagnetic compatibility - Requirements for household appliances , electric tools and similar apparatus - Part 2. Immunity - Product family standard EN 55014-2 (1997) + A1 (2001) following the provisions of the Directives: EC 2006/95 , EC 2004/108. The manufacturer reserves the right to change the features of the product without prior notice. www. philips. com/saeco EN Gaggio Montano li, 28/04/2009 R & D Manager Mr. [. . . ] Each time the " " or " " buttons are pressed and released, the machine brews a pre-set amount of coffee. This amount may be reprogrammed to your taste. Each button may be individually programmed for a specific brew setting. As an example, the following procedure describes the programming of the small coffee button " ", which is normally associated with espresso coffee. · Place a cup under the dispensing spout. · Press and hold down the " " button; the " " light blinks during this phase. · Release the " " button when the amount of coffee in the cup reaches the desired level. At this point the button " " is programmed; each time it is pressed and released, the machine will brew the same amount of coffee that was just programmed. Standby The machine is designed for energy saving. After 60 minutes of inactivity, the machines turns off automatically. Note: During the turning off phase, the machine performs a rinse cycle, if a coffee product has been brewed. To turn the machine on again, simply press the ON/OFF button; in this case the machine will go through the rinse cycle only if the boiler is cold. 1 2 · 11 · COFFEE BREWING Before brewing coffee, make sure that the green temperature light " " is steady on and that the water tank and the coffee hopper are full. Important Note: Immediately after using the steam to froth the milk, clean the steam wand (or Pannarello when provided). When the machine is ready, brew a small amount of hot water in a glass and clean the wand (or Pannarello when provided) externally. In this way, all parts will be perfectly cleaned and free of any milk residue. · Place a container under the hot water / steam wand (Pannarello, if supplied). · When the machine is ready to brew coffee, turn the control dial counterclockwise to set it onto the " " position. Residual water may come out of the wand (Pannarello, if supplied). · The " " light blinks during the preheating time required by the machine. · Steam dispensing will begin when the green light " " remains steady on; soon after only steam will begin to come out. · Turn the control dial clockwise and set it back to the " " position to stop dispensing steam. · Fill 1/3 of the container you wish to use to prepare the cappuccino with cold milk. Use cold milk for better results when preparing a cappuccino. [. . . ] The hole of the hot water / steam wand is clogged. Solutions Connect the machine to the power source. Clean the hole of the hot water / steam wand using a pin. Make sure that the machine is turned off and has cooled before performing this operation. Change coffee blend or adjust the grinder as explained in section "Coffee Grinder Adjustment". [. . . ]