User manual PHILIPS 37353-31-16

[. . . ] â· Never place this equipment near or over a heat radiator or register, nor should it be placed in a built-in installation unless proper ventilation is provided. â· Only operate this equipment using the type of power supply (110V) indicated in this guide and on the equipment's label. If you are unsure which type of power with which your home or building is supplied, consult your local power company. â· Never spill liquid of any kind on the equipment. [. . . ] NOTE: The indicator light on the base unit will illuminate red, once it has been plugged into the electrical outlet. To ensure you have completed the installation successfully, use a handset phone cordless phone or a phone-line testing device to help verify your extension unit has a dial tone. NOTE: The indicator light on base and extension units will blink green when the handset connected to the extension unit is taken off hook. Plug your chosen handset telephone, cordless telephone or phone-line testing device into the single phone connector on your extension unit, and check for a dial tone. If so, you have successfully set up the link between the base and extension units. Insert one end of the provided six-foot phone cord into a functioning wall phone jack. Plug the other end of same phone cord into the phone connector on the base unit labeled LINE. After you have plugged the base unit into an electrical outlet, plug the extension unit into an A/C outlet where you desire connection. NOTE: The indicator light on the extension unit will blink red. As soon as it recognizes the base unit, the indicator light will then illuminate green. The indicator light on the base unit will illuminate green as well, just after it has recognized the extension unit. Plug the other end of a phone cord into the phone jack on the dial-up modem. Look for a green indicator light on the front of the extension unit. Send a test call from the dial-up modem you just connected. If possible, send a test fax from the fax machine you just connected. If you cannot send a test fax, ensure you have a dial tone. If you would like to add extension units to your current setup, or the indicator light on the extension unit remains red after following the proper installation procedure, you must program the new extension unit to function with the other units. Press and release the button on the bottom right side of the base unit (two phone connectors), which puts the base unit into program mode. The indicator light on the base unit will begin to flash orange. this retains the current link code , and allows newly added extension units to obtain the same link code. NOTE: The base unit is in program mode only when the indicator light is flashing orange. NOTE: If you press and hold the button on the base unit and it turns solid red before it begins to flash orange, you need to press and release the button on all extension units. [. . . ] Extension is too far from the base unit. Relocate either the base or extension unit to another electrical outlet. If indicator light on extension unit remains solid red, reprogram the link code on extension unit (see Troubleshooting. Base unit's indi- Either the extension unit has not been installed or it cannot communicate with the base cator light is solid unit. [. . . ]