User manual PHILIPS 37369-48-16

[. . . ] If you are using a voice mailbox from yourprovider, thisiconflasheswhen there is a new message. It remains steadily on when the voice messages are already viewed in the call log. The icon is not shown when there is no voice message. * This is network dependent It displays when you scroll up/down a list or increase and decrease the volume. [. . . ] 2 Connect each end of the line cord to: · the telephone socket at the bottom of the base station; · the telephone socket on the wall. For multi-handset version only: 3 Connect each end of the power adapter to: · the DC input jack at the bottom of the extra handset charger. · the power socket on the wall. Extra handset charger 2 Get started 1 The batteries are pre-installed in the handset. Pull the battery tape off 2 Whenusingyourphoneforthefirsttime, youseeawelcome Configure your phone from the battery door before charging. After the welcome message, press MENU/OK. 3 Please set the country and language if prompted. · If the time is in 12-hour format, press / key to select [AM] or [PM]. Charge your phone Place the handset on the base station to charge the handset. When the handset is placed correctly on the base station, you hear a docking sound. » The handset starts charging. NoteChargethebatteriesfor8hoursbeforefirstuse. Check the battery level Charge 8 hours When the handset is off the base station/charger, the bars indicate the battery level (full, medium and low). When the handset is on the base station/charger, the bars flashuntilchargingcompletes. Theemptybatteryiconflashesandyouhearanalerttone. 2 Select [SERVICES] > [RESEt], then press » The handset displays a confirmationrequest. » All settings are reset » The welcome screen displays. MENU/OKtoconfirm. Adapter on the base station for 5 seconds. » Registration is completed in less than 2 minutes. MENU/OKtoconfirm. Base and charger: · Philips: SSW-1920EU-2/SSW-1920UK-2/ S003PV0600050/S003PB0600050: Input: 100-240V 50/60Hz 0. 2A; Output: 6V 500mA Frequently asked questions I cannot change the settings of my voice mail, what do I do? · The handset is out of range. · If the handset displays [UNREgIStERED], put the handset on the base until the signal bar appears. No signal bar displays on the screen. The voice mail service is managed by your service provider but not the phone itself. Contact your service provider to change the settings. · Ensure the batteries are charged. · Ensure there are power and phone connections. · The handset is nearly out of range. · The phone receives interference from the nearby electrical appliances. · The phone is at a location with thick walls. Move the base away from them. No display Bad audio (crackles, echo, etc. ) If I fail to register the additional handsets to the base station, what do I do?No dialing tone Your base memory is full. [. . . ] Unregister the unused handsets and try again. Move it closer to the base station. · Ensure the batteries are inserted correctly. · Ensure the handset is placed properly on the charger. The battery icon animates when charging. [. . . ]