User manual PHILIPS 40543-12-13

[. . . ] Do not expose the appliance to rain or moisture. Do not use the appliance near a water source, while bathing, while washing hands or while you are in contact with water. If you suffer from an eye disease or have a history of eye disease in your family, consult your ophthalmologist before you use this appliance. If you are experiencing any temporary eye problems, wait until the problems are resolved before using this appliance. [. . . ] For example, when you wake up in the morning, use it for 15 to 30 minutes and then again at midday or in the evening for approximately the same amount of time. Place the goLITE BLU further away from you during the evening session. Do not use the goLITE BLU within two hours of your desired bedtime or you may not be able to fall asleep. Note:You can also use the appliance while it is charging. The goLITE BLU energy light comes with a 9. 5V AC/DC adaptor that operates on voltages ranging from 100 to 240 volts to allow worldwide use. The adaptor comes with a set of exchangeable adaptor plugs that fit most common worldwide wall outlets (model HF3331 only). Note: Charge the goLITE BLU at least 8 hours before you use it for the first time. 2 Insert the bevelled end of the stand into the hole on the back of the appliance. /50-70cm from your eyes in such a way that the light bathes your face from the side (Fig. - You can read, eat, work at the computer, watch TV or exercise while you use your goLITE BLU energy light. Note: If you do not touch the display or press any button for 5 minutes when the display is turned on and the appliance operates on battery power, the appliance turns off automatically to save battery power. Note: If you want to turn off the appliance, press and hold the on/off button for 2 seconds. Note: If you want to turn off the LED panel before the countdown is finished, press the on/off button briefly. Note: If you pause a session while the appliance operates on battery power and do not continue the session within 5 minutes, the appliance turns off automatically. Setting the alarm The alarm has three modes: chime only, light only or both chime and light. 3 Press the plus or minus button to switch between the three alarm modes: chime only, light only or both chime and light (Fig. 4 Press the alarm button twice or wait 10 seconds to store the selected mode. If you keep the button pressed, the time moves forward or backward quickly. 7 Press the alarm button or wait 10 seconds to store the set alarm time. Note:The set alarm mode and time remain stored in the memory as long as there is energy in the battery. Turning off the alarm sound 1 Press any of the touchscreen buttons or the on/off button to turn off the alarm sound when the alarm goes off. [. . . ] The user of the goLITE BLU should make sure it is used in such an environment. emissions TEsT ComplianCE ElECTromagnETiC EnvironmEnT - guidanCE The goLITE BLU uses RF energy only for its internal function. Therefore, its RF emissions are very low and are not likely to cause any interference in nearby electronic equipment. The goLITE BLU is suitable for use in all establishments, including domestic establishments and those directly connected to the public low-voltage power supply network that supplies buildings used for domestic purposes. [. . . ]