User manual PHILIPS 407431716

[. . . ] dANGER of electric shock: To reduce the risk 1.   not reach for a corded razor that has fallen into water.   Power plug is not for immersion or for use in shower.   not use an extension cord with this appliance. [. . . ] Recharge when the charging light on the razor display blinks orange. Indd 12 11/29/12 12:21 P ENGLISH 13 Quick Charge When you charge the empty battery, the charging light alternately blinks orange and green. After approximately 3 minutes, the charging light continues to blink green. The razor now contains enough energy for a 5-minute shave. put It To The Test & Shaving Tips ◗ 21 Day Trial and Conversion Process. It is a fact that your skin and beard need time to adjust to a new shaving system. —  se your new razor exclusively for 3 weeks to U fully enjoy the closeness of a Philips Norelco shave. — At first you may not get as close a shave as you expect, or your face may even become slightly irritated. This is normal since your beard and skin will need time to adjust. Invest 3 weeks and you’ll soon experience the full joy of your new razor. If you alternate shaving methods during the adjustment period, it may make it more difficult to adapt to the Philips Norelco shaving system. When razor is thoroughly dry, put the Protective Cap on the razor to protect heads. C The trimmer can be activated while the razor is running. Cleaning ◗  lways clean your razor after each use. A ◗  lways switch razor OFF, unplug and remove A power cord before cleaning. —  ever clean, remove or replace head N assembly while motor is on. Do not D touch razor heads with hard objects as this may dent or damage precision-made slotted combs. —  o not use razor if combs are damaged or D broken. Indd 16 11/29/12 12:21 P ENGLISH 17 ◗  o not use compressed air, abrasives, D scourers or aggressive liquids such as gasoline or acetone to clean the razor. Cleaning the Shaving Unit The razor heads may be quickly cleaned after each use by rinsing with hot water: Water from the tap should be on a hot setting, BUT BE CAREFUL TO TEST WATER FIRST SO AS NOT TO BURN OR SCALD HANDS. W While rinsing razor heads, water may drip out of the base of razor. 1 Always turn razor OFF, unplug from outlet and remove power cord from razor. [. . . ] 10 Replace the frame and turn the lock clockwise until it locks into place. C 11 1 2 Insert the notch of the shaving unit into the slot in the top of the razor (1) and then close the shaving unit (2). NOTE: If the shaving unit does not close smoothly, make sure you inserted the shaving heads properly and that the retaining frame is locked. 12 Put the Protective Cap on razor to protect heads. [. . . ]