User manual PHILIPS 40759-53-16

[. . . ] saeco recommends using the INTENZA BRITA FILTER (optional accessory). To install the filter follow the instructions provided with the accessory. Incorrect use not in accordance with the intended purposes; · Repairs not carried out by authorized service centres; · Tampering with the power cord; · Tampering with any parts of the machine; · Use of non-original spare parts and accessories; · Use at temperatures below 10°C or above 40°C; · Use at a relative humidity above 95%; · Use of pods other than those indicated. In these cases, the warranty is not valid. [. . . ] PREMIUM: press the manual brew button again to stop dispensing and close the steam / hot water knob. PREMIUM: with this procedure you can dispense up to 250 cc of water for each dispensing. Press the dosed coffee brew button and hold it until the desired quantity of coffee to programme is brewed. Release the dosed coffee brew button and bring the lever back to the off position. Place an empty container under the steam / hot water wand and open the knob slowly for a few seconds to let any residual water Come out until only steam is dispensed. Never use solvents, alcohol, harsh substances to dry the machine components, and never place them in an oven. Wash the components (except the electrical ones) with cold/lukewarm water and non-abrasive cloths/sponges. CLEANING THE STEAM / HOT WATER WAND After using the steam / hot water wand, dispense steam for a few seconds. Clean the wand externally with a damp cloth. Place the milk container in such a way that the steam / hot water wand is closed to its bottom, and then open the knob slowly. the machine will start dispensing steam. Repeat the operations described in step completely empty. Clean the fixed part installed on the steam / hot water wand with a damp cloth. at the end , assemble the outer part again. Make sure this component is inserted up to its limit stop to prevent it from sliding away during operation. After cleaning, we recommend dispensing some steam to complete the process. Rinse the tank with fresh drinking water and fill it up. turn on the machine by pressing the main switch. Dispense the whole content of the tank through the steam / hot water wand. When water is finished, fill the tank again and repeat the operations described in step 11 . DESCALING Limescale normally builds up with extended use of the appliance; the machine needs descaling every 3 - 4 months and/or whenever a reduction in water flow is noticed. In case of con ict, priority must be given to what is indicated in the operation and maintenance manual over the instructions provided on separately sold accessories and materials. [. . . ] Place the coffee machine in a safe place, where nobody may overturn it or be injured by it. Do not keep the machine at a temperature below 0°C (32°F) as freezing may damage it. Do not place the machine on very hot surfaces or close to flames. Only connect the coffee machine to a suitable socket. [. . . ]