User manual PHILIPS 40760-53-16

[. . . ] Danger Make sure the adapter does not get wet (Fig. Always check if the water is not too hot, to prevent your hands from getting burnt. Do not cut off the adapter to replace it with another plug, as this causes a hazardous situation. These appliances are not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliances by a person responsible for their safety. [. . . ] If you have a heavy beard, the shaving time may be less than 65 minutes. The shaving time may also vary over time, depending on your shaving behaviour and beard type. Quick charge After the shaver has charged for 5 minutes, it contains enough energy for one shave. First insert the top of the shaver into the Power Pod (1) and then press the bottom part into the Power Pod (2) (Fig. Note:The shaver cannot be placed in the Power Pod when the protection cap is on the shaving unit. Place the shaver upside down in the holder with the display pointing towards the front of the Jet Clean System (Fig. Note: RQ1090, RQ1062, RQ1060 only: when you turn the shaver upside down, the indications on the display are also turned upside down so you can still see the remaining battery capacity. Press the shaver tightly into the holder to lock it into place (Fig. Note:The shaver cannot be placed in the Jet Clean System when the protection cap is on the shaving unit. , The display shows that the shaver is charging (see chapter `The display'). Using the shaver shaving 1 Press the on/off button once to switch on the shaver. Preparing the Jet Clean system for use Fill the cleaning chamber before first use. Simultaneously press the release buttons on both sides of the cleaning chamber (1). Then lift the Jet Clean System off the cleaning chamber (2). Make sure the release buttons click back into place. , Duringthefirstphaseofthecleaningprogram, theshaver automatically switches on and off several times and moves up and down. , During the second phase of the cleaning program , the shaver is placedinthedryingposition , indicatedbyaflashingdryingsymbol. The shaver stays in this position until the end of the program. Note: If you press the on/off button of the Jet Clean System during the cleaning program, the program aborts and resets. In this case, the cleaning or drying light stops flashing and the holder returns to its starting position. Note: If you remove the adapter from the wall socket during the cleaning program, the program aborts. the holder remains in its current position. [. . . ] Replace the shaving unit when the shaving unit symbol appears on the display. replace a damaged shaving unit right away. For maximum shaving performance, we advise you to replace the shaving unit every two years. Only replace the shaving unit with an original RQ10 Philips arcitec Shaving Unit. [. . . ]