User manual PHILIPS 40770-35-16

[. . . ] Allow to cool before putting on or taking off parts, and before cleaning the appliance. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or has been damaged in any manner. The use of accessory attachments not recommended by the appliance manufacturer may result in fire, electric shock or injury to persons. Do not let cord hang over edge of table or counter, or touch hot surfaces. [. . . ] The Saeco coffee machine is equipped with a self-adjusting system that allows the use of all types of coffee beans available on the market (not including flavored or carmelized). ⷠThe machine automatically adjusts itself in order to optimize the extraction of the coffee, ensuring perfect compression of the beans to obtain a creamy espresso coffee that is able to release all the aromas, regardless of the type of coffee used. ⷠThe optimization process is a learning process that requires the brewing of a certain number of coffees to allow the machine to adjust the compactness of the ground coffee. ⷠAttention should be given to special blends, which require grinder adjustments in order to optimize the extraction of the coffee (see section "Coffee Grinder Adjustment"). In this way, the machine has been programmed to inform the user of the need to replace the filter. Note: When an "Intenza" filter must be replaced with a new one, the function must be reset. replace the filter as previously shown. After that, enter the programming menu until the indicated window is displayed and select the "RESET" option; then press the " " button. The machine is now programmed to manage a new filter. Note: If the filter is already installed and you want to remove it, without replacing it, select the "OFF" option and then press the " " button. The grinder adjustment knob, inside the coffee bean hopper, must be turned only when the grinder is working. Selection can be made when the beans appear on the display. Each time the " " button is pressed and released, the aroma changes by one degree: = Mild aroma = Medium aroma This feature may slightly lengthen the brewing time, allowing the intense flavor of the coffee to develop fully. Other substances and objects may cause severe damages to the machine. Such damages will not be covered by warranty. After the pre-brewing cycle, coffee begins to come out of the dispensing head. After dispensing the product, the machine defaults back to the whole coffee bean configuration. Repeat the operations described above to brew other coffees. This function allows using pre-ground and decaffeinated coffee. Pre-ground coffee must be poured into the bypass doser positioned next to the coffee bean hopper. Only use coffee ground for espresso machines and never coffee beans or instant coffee. note: · If no pre-ground coffee is poured into the bypass doser, only water will be dispensed; · If the dose is excessive and 2 or more measuring scoops of coffee are used, the machine will not brew the product. [. . . ] (see note) The machine takes a long time to warm up or the amount of water dispensed from the wand is too little. The machine is not connected to the power Connect the machine to the power source. Clean the hole of the steam wand using a pin. Make sure that the machine is turned off and has cooled before performing this operation. [. . . ]