User manual PHILIPS 42FD9932/01S

[. . . ] Connect the switchable adaptor for Apple video connectors to one end of a VGA cable. Put the DIP switches on the adaptor in the following positions : 1 off 2 off 3 on 4 on Connect the end of the VGA cable with the adaptor to the video card of the computer and the other end to the VGA IN connector on the back of the monitor. Screw the connectors down firmly. a 15-pin D sub (2-row) * 15-pin mini D sub (3-row) Apple Macintosh is a registered trademark of Apple Computer, Inc. 1 English Use of the remote modes Computer Display control VGA VGA VGA VGA VGA MAC II SVGA SVGA XGA XGA 640x480 640x400 640x350 856x480 800x450 640x480 800x600 800x600 1024x768 1024x768 31. 468 31. 468 31. 468 31. 468 31. 490 35. 000 35. 156 37. 880 45. 000 48. 360 kHz kHz kHz kHz kHz kHz kHz kHz kHz kHz 60 70 70 60 65 67 56 60 56 60 Hz Hz Hz Hz Hz Hz Hz Hz Hz Hz When a VGA computer is connected, the selection is made automatically. [. . . ] Press the MENU key again to switch the menu off. 3 Tips Ambient temperature Do not hang up the monitor above a central heating or other heating sources. Active Loop Through The Active Loop Through facility makes it possible to make a daisy chain for VGA. Care of the screen Clean the anti-reflex coated flat glass screen with a slightly damp soft cloth. Do not use abrasives solvents as it can damage the glass surface of the screen. Plasma Display characteristics When switching over to another picture after having displayed the same still picture for a long time (many hours), it may happen that some parts from the previous picture will remain on screen due to a kind of memory effect. This ghost picture will disappear after some time. To avoid this effect change the pictures regularly or for PC use you can turn on a screen saver in your computer. Philips has built in an automatic shift of the picture every 5 minutes to avoid this effect and to prolong the life of the screen. Very incidentally and after a longer period of unuse (approx. 1 year) the screen may display some strange colour deficiencies. This is quite normal for plasma displays and these effects will disappear after the set has been turned on for some time. A plasma display consists of more than 1, 2 Million colour pixels. It is within industry standards that very few pixels (< 0. 001%) may be defective, even for a new set. There is however no reason to doubt about the quality of the set. The plasma display technology operates with rare gases which are being influenced by air pressure. Up to an altitude of 2000 m above sea-level, the display is functioning fine. [. . . ] Transport Keep the original packaging to transport the monitor if needed. End of life directives Philips is paying a lot of attention to produce environmentally-friendly in green focal areas. Your new monitor contains materials which can be recycled and reused. At the end of its life specialised companies can dismantle the discarded monitor to concentrate the reusable materials and to minimise the amount of materials to be disposed of. [. . . ]