User manual PHILIPS 42FD9944-69S

[. . . ] In case of a Multimedia computer, connect the audio cable to the audio outputs of your Multimedia computer and to the AUDIO VGA R (right) and L (left) inputs of the receiver box. Directly to the monitor Connect one end of a VGA cable 1 to the video card of the computer and the other end to the VGA 1 connector at the rear side of the monitor. Fix the connectors firmly with the screws on the plug. In case of a Multimedia computer, connect the audio cable 2 to the audio outputs of your Multimedia computer and to the AUDIO VGA 1 R (right) and L (left) inputs of the TV monitor. [. . . ] 4. ZOOM IN/OUT to adjust the zoom factor 1 4 7 AV MUTE 2 5 8 0 3 6 9 q and to change the magnification of the picture when zoom is activated. 4. ¬ Mute key Temporarily mute the sound or restore it CH/PR Programme selection To browse through the sources selected. AV MUTE to temporarily mute the picture and the sound or restore it. When activated a yellow indicator starts blinking in front of the monitor. Press the q key to switch between the different picture formats. Use of the remote control 3 1011. 5 gb 03-10-2003 11:18 Pagina 4 Use of the menus and the menu system Picture 1 Picture 2 Sound Setup & é " Brightness Contrast Colour temperature Sharpness Press the MENU key on the remote control to summon the different menu headers. Press the cursor left/right to move the cursor horizontally through the menu headers. Press the cursor down to access the menu. In case of a slider, move the cursor left/right to adjust. In case of a list with options, move the cursor right to enter and use the cursor up/down to select an option. Press the cursor left to leave the options list. ` Press the MENU key again to switch off the menu. Note: Sometimes not all the menu items are visible on the screen. Press the cursor down until all the items are displayed. Only when the US English language has been selected (see Setup menu, Language, p. 5), the menu items will be displayed with additional icons. Operation Press the MENU key on the remote control to summon the main menu. Picture 1 menu Brightness This control allows you to adjust the brightness level of the picture. Picture 1 Brightness Contrast Colour temperature Sharpness Contrast This control allows you to adjust the contrast level of the picture. Colour temperature This control allows you to select the colour temperature of the picture. Move the cursor up/down to make a selection. Press the cursor left to return to the Picture 1 menu. Sharpness This control allows you to adjust the edge definition of a picture. Picture 2 Format Zoom Zoom factor Shift Clock frequency Phase Auto align Picture 2 menu 4:3 Wide screen In this menu you are allowed to adjust attributes which are relevant for the picture on the display, like format, zoom, size, etc. Format Select Format to summon a list of available display formats for showing images in the traditional 4:3 proportions. Press the cursor up/down to select another display format: 4:3 or Wide screen. Zoom Select Zoom On to activate the zoom function. You may also activate the zoom function with the ZOOM ON/OFF key on the remote control. Press the cursor left/right, up/down to select which part of the screen will be zoomed. [. . . ] A plasma display consists of a high number of colour pixels. It is within industry standards that very few pixels (< 0. 001%) may be defective, even for a new set. There is however no reason to doubt about the quality of the set. The plasma display technology operates with rare gases which are being influenced by air pressure. Up to an altitude of 2000 m above sealevel (local air pressure equal or above 800 hPa), the display is functioning fine. [. . . ]