User manual PHILIPS 42FD9953-93S

[. . . ] Connect one end of another VGA cable to the VGA 2 connector at the rear side of the monitor and the other end to the VGA 1 connector of a second monitor. In case of a Multimedia computer, also connect audio cables to the AUDIO L and R outputs of the original monitor and to the AUDIO L and R inputs of the second monitor. The RC out jack next to the VGA 2 connector makes it possible to daisy chain remote control signals to other equipment. This output cannot be used to daisy chain a second monitor. [. . . ] Press the cursor left/right to move the cursor horizontally through the menu headers. Press the cursor down to access the menu. In case of a slider, move the cursor left/right to adjust. In case of a list with options, move the cursor right to enter and use the cursor up/down to select an option. Press the cursor left to leave the options list. ` Press the MENU key again to switch off the menu. Note: Sometimes not all the menu items are visible on the screen. Press the cursor down until all the items are displayed. Only when the US English language has been selected (see Setup menu, Language, p. 5), the menu items will be displayed with additional icons. Operation Press the MENU key on the remote control to summon the main menu. Picture 1 menu Brightness This control allows you to adjust the brightness level of the picture. Picture 1 Brightness Contrast Colour temperature Sharpness Contrast This control allows you to adjust the contrast level of the picture. Colour temperature This control allows you to select the colour temperature of the picture. Move the cursor up/down to make a selection. Press the cursor left to return to the Picture 1 menu. Sharpness This control allows you to adjust the edge definition of a picture. Picture 2 Format Zoom Zoom factor Shift Clock frequency Phase Auto align Picture 2 menu 4:3 Wide screen In this menu you are allowed to adjust attributes which are relevant for the picture on the display, like format, zoom, size, etc. Format Select Format to summon a list of available display formats for showing images in the traditional 4:3 proportions. Press the cursor up/down to select another display format: 4:3 or Wide screen. Zoom Select Zoom On to activate the zoom function. You may also activate the zoom function with the ZOOM ON/OFF key on the remote control. Press the cursor left/right, up/down to select which part of the screen will be zoomed. [. . . ] It is within industry standards that very few pixels (< 0. 001%) may be defective, even for a new set. There is however no reason to doubt about the quality of the set. The plasma display technology operates with rare gases which are being influenced by air pressure. Up to an altitude of 2000 m above sealevel (local air pressure equal or above 800 hPa), the display is functioning fine. Operating the set at a higher altitude (lower air pressure), the picture becomes unstable and the picture performance is deteriorating. [. . . ]