User manual PHILIPS 42PF7420

[. . . ] 2446. 2 en. qxd 03-08-2006 15:32 Pagina 1 Introduction Help?If this instruction manual does not give an answer or if `Tips' do not solve your TV problem, you can call your Local Philips Customer or Service Centre. See the supplied World-wide guarantee booklet. Please, have the Model and Product number which you can find at the back of your television set or on the packaging, ready, before calling the Philips helpline. [. . . ] 10 p 11 12 13 & Select Sort in the Install menu and press the cursor right é Select the TV channel you want to move using the cursor up/down and press cursor right. " Select the new number and validate with the cursor left. ` Repeat steps é and " for each TV channel you wish to renumber. ( To exit the menus, press the MENU key repeatedly. 14 2446. 2 en. qxd 03-08-2006 15:32 Pagina 15 Manual store Install Language Colour System Auto Store Sound System Manual Store Search Sort Channel Name Fine tune Channel edit Searching for and storing TV channels is done channel by channel. You must go through every step of the Manual Installation menu. & Select Manual Store in the Install menu and press the cursor right to enter. é Select Colour system and press the cursor right. If Auto is selected, the respective colour system will be automatically selected according to the transmission system. If the reception is poor, select another colour system with the cursor left/right. ` Select Sound system and press the cursor right. If Auto is selected, the respective sound system will be automatically selected according to the transmission system. Note: if the reception is poor, select another sound system with the cursor left/right. ( Press the cursor down. § Search for a TV channel: Press the cursor down to select Search and press the cursor right to start searching. Direct selection of a TV channel: If you know the frequency, enter it directly with the digit keys 0 to 9. Ask for a list from your cable company or dealer, alternatively consult the Table of frequencies on the inside backcover of this handbook. è Press the cursor down and enter the programme number with the digit keys. Fine tune: In case of poor reception, you can improve the reception by adjusting the frequency with the cursor left/right. ç To store your TV channel, select Store and press the cursor right. 0 To exit from the menu press the MENU key on the remote control repeatedly. 15 2446. 2 en. qxd 03-08-2006 15:32 Pagina 16 Give name It is possible to change the name stored in the memory or to assign a name to a TV channel or external for which a name has not yet been entered. A name with up to 5 letters or numbers can be given to the programme numbers 0 to 99. Note : It is not possible to rename the VGA source. & Select Name in the Install menu and press the cursor right. ` Select the following character with the cursor up/down. ( Select the following position with the cursor right. è Press the cursor left repeatedly when finished. Select another programme number and repeat steps é to è. ç Press the MENU key to return to the TV menu. [. . . ] · Do you see a black screen and the indicator in front of the TV lights up green, this means that the display mode is not supported. Switch your VGA- or HDMI-source to a correct mode. · In case of weak or bad signal, consult your dealer. No Picture No picture and · Your TV has a protective mode in case there is too much heat build-up. power switched on Check the clearance around the vents of the device to be certain there are no blocking walls or cabinets which would limit the air flow. Digital distortion The low quality of some digital picture material may be the cause of digital image distortion. [. . . ]