User manual PHILIPS 43259-53-16

[. . . ] Replace only with the same or equivalent type. The unit shall not be exposed to dripping or splashing. Do not place any sources of danger on the unit (e. g. liquid filled objects, lighted candles). [. . . ] k FM antenna • Improve FM reception. l TUNING +/• Tune to FM radio stations. k l m n o p m VOL +/• Adjust volume n Source selector • Select a source. o AUDIO-IN • Connect an external audio device. p AC~MAINS EN 3 • Connect power. 4 EN 3 Get started Caution •• Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. AC~MAINS Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of your apparatus. The model number and serial number are on the bottom of your apparatus. ___________________________ Option 2: Battery power Caution •• Batteries contain chemical substances, so they should be disposed of properly. Connect power The unit can be powered by either AC power or batteries. Note •• Batteries are not supplied with the accessories. Option 1: AC power Warning supply voltage corresponds to the voltage printed on the back or the underside of the unit. When you disconnect the AC power, always pull the plug from the socket. Never pull the cord. 1 2 3 Open the battery compartment. Insert 6 batteries (type: 1. 5V R14/UM2/C CELL) with correct polarity (+/-) as indicated. Close the battery compartment. •• Risk of product damage!Press / to select a track number, then press PROG to confirm. »» During play, [PROG] (program) is displayed. • To erase the program, press twice. • To review the program, when playback is stopped, press and hold PROG for 2 seconds. PROG +VOLUMEREPEAT Adjust sound During play, you can adjust volume and select the sound effects. Key +VOLUMEDBB Function Increase or decrease volume. Turn dynamic bass enhancement on or off. SHUFFLE Tip •• Only [ ] and [ ] can be selected when you play the programmed tracks. Program tracks In CD mode, you can program a maximum of 20 tracks. 1 Press to stop playback. EN 9 6 Product information Note •• Product information is subject to change without prior notice. Signal to Noise Ratio >50 dBA Tape deck Frequency response - Normal tape (type I) Signal-to-noise ratio - Normal tape (type I) Wow and flutter 125 - 8000 Hz (8 dB) 35 dBA ≤ 0. 4% DIN Specifications Amplifier Max Output Power Frequency Response Signal to Noise Ratio Total Harmonic Distortion Audio-in Input Total 2 W RMS 125 -16000 Hz, -3dB >55 dBA <1 % 650 mV RMS General Power supply - AC Power - Battery Operation Power Consumption Standby Power Consumption Dimensions - Main Unit (W x H x D) Weight (Main Unit) 220-240V~, 50/60 Hz; 9 V, 6 x 1. 5 V type: R14/UM2/C CELL 15 W <0. 5 W 299 x 240 x 132 mm 1. 8 kg Disc Laser Type Disc Diameter Support Disc Audio DAC Total Harmonic Distortion Frequency Response S/N Ratio Semiconductor 12cm/8cm CD-DA, CD-R, CD-RW 24Bits / 44. 1kHz <1% 125 -16000 Hz, -3dB >55 dBA Maintenance Clean the cabinet • Use a soft cloth slightly moistened with a mild detergent solution. Do not use a solution containing alcohol, spirits, ammonia or abrasives. Clean discs • When a disc becomes dirty, clean it with a cleaning cloth. Wipe the disc from the centre out. Tuner Tuning Range Tuning grid Total Harmonic Distortion 10 EN 87. 5 108MHz 50 kHz <3% 7 Troubleshooting Warning •• Never remove the casing of this device. Do not use solvents such as benzene, thinner, commercially available cleaners, or antistatic spray intended for analogue records. Clean the disc lens • After prolonged use, dirt or dust may accumulate at the disc lens. To ensure good play quality, clean the disc lens with Philips CD lens cleaner or any commercially available cleaner. [. . . ] • Ensure that a NORMAL (IECI) cassette tape is used for record. Cassette does not work for record • Ensure that cassette tabs are not broken. No disc detected •• Insert a disc. •• Check if the disc is inserted upside down. [. . . ]