User manual PHILIPS 45576-17-16

[. . . ] Do not place or drop a razor or Jet Clean System into water or other liquid. Always unplug this razor/Jet Clean System from the electrical outlet immediately after use, except when razor is (re)charging. Unplug and remove power supply cord from razor before cleaning. Keep the razor, Jet Clean System, cord and charging plug away from heated surfaces. [. . . ] When batteries are totally depleted, recharging the razor for approximately 3 minutes gives enough energy for a 3-minute cordless shave. All of the lights on the Charge Meter will blink green sequentially when the battery contains enough energy for a 3-minute cordless shave. When batteries are fully charged, the charging light on the Jet Clean System will light up continuously. You may store your razor in the Jet Clean System. Unplug from outlet when charging/cleaning is complete. It is a fact that your skin and beard need time to adjust to a new shaving system. Use your new razor exclusively for 3 weeks to fully enjoy the closeness of a Philips Norelco shave. At first you may not get as close a shave as you expect, or your face may even become slightly irritated. This is normal since your beard and skin will need time to adjust. Invest 3 weeks and you'll soon experience the full joy of your new razor. If you alternate shaving methods during the adjustment period, it may make it more difficult to adapt to the Philips Norelco shaving system. Do not use razor if combs are damaged or broken. (model #HQ9) once a year or when the replacement head indicator light starts blinking. The light above faucet symbol will start blinking after each shave to remind you that the razor needs to be cleaned (except when the bottom light burns red). Use this appliance for its intended household use as described in this manual. Important Only use the razor, power plug, Jet Clean System and HQ200 cleaning solution provided to charge or clean razor. Only use a Philips Norelco `XLCC' model razor with the Jet Clean System. Other Philips Norelco`X', `XL' or`LC' model razors DO NOT work with a Jet Clean System. Empty the cleaning solution canister and thoroughly rinse the canister clean with warm water every 2 weeks. The Jet Clean System thoroughly cleans but does not disinfect your razor, therefore, do not share razor with others. Be careful not to tip or move the Jet Clean System if it is filled with the cleaning solution. to avoid evaporation , do not expose cleaning solution to direct sunlight. [. . . ] Water from the tap should be on a warm setting to clean all washable parts. Simply rinse the canister with warm water. Carefully lower the Jet Clean System over the canister making sure the release buttons snap back into position. Replace the razor heads once a year for optimal shaving results. [. . . ]