User manual PHILIPS 51-PROJECTION HDTV PIXEL PLUS 51PP9200D

[. . . ] Retain this information for future reference. Com/usasupport or call 1-888-PHILIPS (744-5477) while with your product (and Model / Serial number) How to make the optimal connection Provides superior picture quality by separating the green, blue and red luminance signals. Supplies a better picture than RF and Composite connections. Separate video (yellow) and audio (red/white) cables that provide a basic connection from the cable box and other devices. [. . . ] If various images in the picture have blue outlines, select CONVERGE BLUE. ( Use the cursor right, left, up or down button to adjust the cross hair until the colour outline is gone. The adjustment is automatically saved in the TV's memory when you exit the adjust mode. § Press the MENU button to return or the INFO key to switch the menu off. Manual convergence Convergence red Convergence blue Multipoint red Multipoint blue Save multipoint Save undo multipoint Restore factory Save Manual convergence undo multipoint Restore factory Start now If any colour outlines remain around the images, use the MULTIPOINT RED (for red outlines) or MULTIPOINT BLUE (for blue outlines) control. See the next section for instructions for using those controls. Manual convergence Convergence red Convergence blue Multipoint red Multipoint red Save multipoint Save undo multipoint Restore factory The Multipoint Red/Blue convergence controls allow you to adjust picture convergence at specific points on the TV screen. " Use the cursor left, right, up or down button to move to a cross hair that has a colour outline. ` Press the INFO button to enter adjust mode. ( Use the cursor left, right, up or down to adjust the cross hair until the colour outline is gone. Manual convergence Convergence red Convergence blue Multipoint red Multipoint blue Save multipoint Save undo multipoint Restore factory Save multipoint Start now Manual convergence Convergence red Convergence blue Multipoint red Multipoint blue Save multipoint Save undo multipoint Restore factory è Repeat steps 3-6 until all misaligned cross hairs have been adjusted. For your multipoint adjustments to be stored in the TV's memory, you must activate SAVE UNDO MULTIPOINT. Manual convergence Convergence red Convergence blue Multipoint red Multipoint blue Save multpoint Save undo multipoint Restore factory Save undo multipoint Start now Manual convergence Convergence red Convergence blue Multipoint red Multipoint blue Save multpoint Save undo multipoint Restore factory Note: If you are not satisfied with the adjustments you just made and want to start over, you can use the UNDO MULTIPOINT control. This control allows you to undo the adjustments, but only if you use it before saving. Manual convergence Convergence red Convergence blue Multipoint red Multipoint blue Save multpoint Save undo multipoint Restore factory Restore factory Start now Manual convergence Convergence red Convergence blue Multipoint red Multipoint blue Save multpoint Save undo multipoint Restore factory To restore the TV's picture convergence to factory settings, select RESTORE FACTORY and press the cursor right or OK button. The TV menu gives you an overview of the menus you can select. Note: Depending on the input signal, one or more menu items may not be selectable. Press the cursor right button again to enter the Picture menu. select the menu items with the cursor up/down buttons. Adjust the settings with the cursor left/right buttons or enter the list of submenu items with the cursor right button. This gives you an overview of the menus you can select. Select Auto picture to display a list of predefined picture settings, each corresponding with specific factory settings. [. . . ] After a few seconds it will display the status of the upgrade procedure. If you try to upgrade to a software version equal or lower than the current version, a confirmation will be asked. Downgrading to older software should only be done in case of real necessity. ( When the software upgrade was successful, remove the USB portable memory and restart your TV with the power switch . [. . . ]