User manual PHILIPS 55690-17-16

[. . . ] Press REDIAL/C to read. 1 Connect Telephone socket Power socket Power socket Power adapter Connect the base station 1 Connect each end of the power adapter to: Telephone base station 2 1 3 · the DC input jack at the bottom of the base station; · the power socket on the wall. 2 Connect each end of the line cord to: · the telephone socket at the bottom of the base station; · the telephone socket on the wall. For multi-handset version only: 3 Connect each end of the power adapter to: · the DC input jack at the bottom of the extra handset charger. · the power socket on the wall. Extra handset charger 2 Get started 1 The batteries are pre-installed in the handset. [. . . ] · the power socket on the wall. Extra handset charger 2 Get started 1 The batteries are pre-installed in the handset. Pull the battery tape off 2 Whenusingyourphoneforthefirsttime, youseeawelcome Configure your phone from the battery door before charging. After the welcome message, press MENU/OK. 3 Please set the country and language if prompted. · If the time is in 12-hour format, press / key to select [AM] or [PM]. Charge your phone Place the handset on the base station to charge the handset. When the handset is placed correctly on the base station, you hear a docking sound. » The handset starts charging. NoteChargethebatteriesfor8hoursbeforefirstuse. Check the battery level Charge 8 hours When the handset is off the base station/charger, the bars indicate the battery level (full, medium and low). When the handset is on the base station/charger, the bars flashuntilchargingcompletes. Theemptybatteryiconflashesandyouhearanalerttone. The battery is low and needs recharging. 3 Call Enjoy Phonebook Add record 1 Press MENU/OK, then select [PHONEBOOK] > [ADD NEW], then press MENU/OKtoconfirm. 2 Select [SERVICES] > [RESEt], then press MENU/OKtoconfirm. 3 Press MENU/OKtoconfirm. Technical data · CORUN: 2 x AAA NiMH 1. 2V Rechargeable 500mAh batteries · SANIK: 2 x AAA NiMH 1. 2V Rechargeable 500mAh batteries Battery » Thehandsetdisplaysaconfirmationrequest. Power adapter » All settings are reset » The welcome screen displays. Base and charger: · Philips: SSW-1920EU-2/SSW-1920UK-2/S003PV0600050/ S003PB0600050: Input: 100-240V 50/60Hz 0. 2A; Output: 6V 500mA Frequently asked questions I cannot change the settings of my voice mail, what do I do? · The handset is out of range. · If the handset displays [UNREgIStERED], register your handset (See the section on Register the handsets). No signal bar displays on the screen. The voice mail service is managed by your service provider but not the phone itself. Contact your service provider to change the settings. If I fail to register the additional handsets to the base station, what do I do?No dialing tone Your base memory is full. Unregister the unused handsets and try again. Move it closer to the base station. · Ensure the batteries are inserted correctly. · Ensure the handset is placed properly on the charger. The battery icon animates when charging. · The charging contacts are dirty. [. . . ] · Ensure the handset is placed properly on the charger. The battery icon animates when charging. · The charging contacts are dirty. Disconnectthepowersupplyfirstand clean the contacts with a damp cloth. [. . . ]