User manual PHILIPS 55PP9753 Setup Guide

[. . . ] Quick Use and Setup Guide HDTV Monitor TM with Pixel PlusTM Contents Warning . . 6-7 Using Auto IntelliSenseTM to Adjust Picture Convergence . . 8 NOTE: Your Philips projection television has three color picture tubes that are aligned at the factory to make the light beams come together, or converge, on the screen properly. Transporting or moving the TV can cause the tubes to be misaligned. [. . . ] Replay mode displays a few seconds of stored video in the PIP window. Photo Finish mode displays six stored frames from the picture. NOTE: Continuing to hold the Freeze Format button down will cycle the TV through the Freeze modes: Freeze, Replay, and Photo Finish. VOL (Volume) Press + or ­ to adjust the volume. Digit (Number Buttons) Press to directly access a specific TV channel. For a twoor three-digit channel, enter all numbers. Press a singledigit button and hold a bit longer to directly access a single-digit channel. These buttons can also be used to enter values in certain on-screen menu controls. P P (AutoSurfTM) If you set the Surf control in the TV's on-screen menu to two channels, this button will allow you to toggle between the current channel and the last viewed channel. If you choose the nine-channel Surf, pressing this button allows you to access the Surf list, where you can add, remove, and scroll up to nine of your favorite channels. See page 59 in the Directions for Use manual. Picture Format Press to display a list of available picture formats for showing video images in the traditional 4:3 proportions. Press this button repeatedly to select a picture format. Choose from Automatic, Super zoom, Panoramic, 4:3, Movie expand 14:9, Movie expand 16:9, 16:9 subtitle, and Wide screen. See pages 35­36 in the Directions for Use manual. NOTE: To switch between a full or 4:3 letterbox picture format in Dual Screen mode, press the Picture Format button. Active Control PlusTM NOTE: Active ControlTM Plus is not available for use with the AV3 and AV4 input sources. Press to display the Active Control PlusTM screen. With the "Active Control" submenu selected, press the Cursor Up or Down button to select Off, Minimum, Medium, or Maximum. Press the Cursor Right button to select the "Auto Picture" or "Active Display" submenus, then press the Cursor Up or Down buttons to make selections. See pages 27-29 in the Directions for Use manual. ® ® ® ® Active Control Plus, AutoSurf, Incredible Surround, and Pixel Plus are trademarks of Philips Consumer Electronics. Copyright 2003 Philips Consumer Electronics. [. . . ] If you are setting up the TV after turning it on for the first time, skip steps 1-3. If you are returning to the Autoprogrammenu , use steps 1-3 below. . Picture Sound Features Channels TV TV Settings Demo Install Language 6 7 2 4 6 8 3 5 9 1 10 Settings Demo Install Autoprogram Install mode Install The TV will search for, find and store all the available channels. Press the cursor down to proceed. Autoprogram Install mode Install Automatic Keep the predefined automatic detection of cable or anntenna or make your own selection. 1 2 3 4 5 6 7 8 9 10 Press the MENU button on the remote control to show the on-screen menu. Press the Cursor Down button repeatedly until "Install" is highlighted. [. . . ]