User manual PHILIPS 56393-17-13

[. . . ] Do not place or drop a razor or Jet Clean System into water or other liquid. Always unplug this razor/Jet Clean System from the electrical outlet immediately after use, except when razor is (re)charging. Unplug and remove power supply cord from razor before cleaning. Keep the razor, Jet Clean System, cord and charging plug away from heated surfaces. [. . . ] Do not keep razor or Jet Clean System permanently plugged into outlet. It is a fact that your skin and beard need time to adjust to a new shaving system. Use your new razor exclusively for 3 weeks to fully enjoy the closeness of a Philips Norelco shave. At first you may not get as close a shave as you expect, or your face may even become slightly irritated. This is normal since your beard and skin will need time to adjust. Invest 3 weeks and you'll soon experience the full joy of your new razor. Being automatically (re)charged and will light up continuously when fully charged. When batteries are fully charged, the charging light on the Jet Clean System will light up continuously. If you alternate shaving methods during the adjustment period, it may make it more difficult to adapt to the Philips Norelco shaving system. If you are still not convinced after 21 days, Philips Norelco will refund you the full purchase price, guaranteed. The trimmer can be activated while the razor is running. Use this appliance for its intended household use as described in this manual. Turn the reservoir cap counterclockwise (1) and remove from the cleaning reservoir (2). Unscrew the lid on the Jet Clean Solution bottle (Model HQ200) provided with the razor. remove the airtight seal by lifting up the tabs on the seal. Replace lid on the bottle making sure the lid is screwed on securely. open lid and pour the Jet Clean Solution into the transparent cleaning reservoir. The reservoir can be completely filled with one (1) bottle of the Jet Clean Solution (Model HQ200). Discard cleaning solution bottle after contents have been poured into the reservoir. When the level gets low, refill with Philips Norelco HQ200 Cleaning Solution. The cleaning solution is automatically supplied from the reservoir to the cleaning canister through a special mechanism in the reservoir cap. Fill the cleaning reservoir with cleaning solution (see `Preparing Jet Clean System For Use'). [. . . ] While rinsing razor heads, water may drip out of the base of razor. When the entire cleaning cycle is complete and the razor is hygienically clean, the razor will be raised to the highest position and the cleaning light on the Jet Clean System will light up continuously. Raise the lever holding the razor to the highest position (1) and carefully remove the razor from the Jet Clean System (2). Always turn razor OFF, unplug from outlet and remove cord from razor before cleaning. [. . . ]