User manual PHILIPS 56440-11-16

[. . . ] Trimmer (all types except HQ6922, HQ6920) Clean the trimmer every time you have used it. Remove the mains plug from the wall socket and pull the appliance plug out of the shaver. Tip: Lubricate the trimmer teeth with a drop of sewing machine oil every six months (Fig. Replacement Replace the shaving heads every two years for optimal shaving results. [. . . ] - HQ110 Philips Shaving Head Cleaning Spray. Environment Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. By doing this, you help to preserve the environment (Fig. Always remove the battery before you discard and hand in the appliance at an official collection point. dispose of the battery at an official collection point for batteries. If you have trouble removing the battery, you can also take the appliance to a Philips service centre. The staff of this centre will remove the battery for you and will dispose of it in an environmentally safe way. Note:You can also shave without charging. simply connect the shaver to the mains. 4 Remove the mains plug from the wall socket and pull the appliance plug out of the shaver when the battery is fully charged. 2 Move the shaving heads over your skin. Note: If you optimise the battery capacity in this way, you can also charge the shaver in between shaves, even if the battery is not completely empty yet. Contact the Customer Care Centre in your country about the availability of this accessory. You can also clean the shaver in the following way: Every week: shaving unit and hair chamber 1 Switch off the shaver. Remove the mains plug from the wall socket and pull the appliance plug out of the shaver. 3 Press the release button (1) and remove the shaving unit (2) (Fig. 4 Clean the inside of the shaving unit and the hair chamber with the cleaning brush (Fig. Every two months: shaving heads 1 Switch off the shaver. Remove the mains plug from the wall socket and pull the appliance plug out of the shaver. 2 Press the release button (1) and remove the shaving unit (2) (Fig. Make sure the battery is completely empty when you remove it. Remove the mains plug from the wall socket and pull the appliance plug out of the shaver. [. . . ] Com or contact the Philips Consumer Care Centre in your country (you find its phone number in the worldwide guarantee leaflet). If there is no Consumer Care Centre in your country, go to your local Philips dealer. Guarantee restrictions The shaving heads (cutters and guards) are not covered by the terms of the international guarantee because they are subject to wear. Troubleshooting This chapter summarises the most common problems you could encounter with the appliance. [. . . ]