User manual PHILIPS 69182-31-PH

[. . . ] You can move your finger across the wheel to adjust the light level (for dimmable bulbs only). You can control the two luminaires together or each one individually. In order to control a single luminaire, you need to select it. You can do this by using one of the light selection buttons. [. . . ] You can continue adjusting the lights as you wish. Whenever you want to go back to your stored scene, just press the Scene button you pressed when storing it. That Scene button will light up briefly to show that the scene is selected, and the luminaire will go to your stored settings. You can store up to 3 scenes (one for each Scene button). switch the luminaires off by pressing the "0" (off) button briefly. The light level of both will dim slowly until they switch off after 12 seconds. If you press "0" again, the lamps switch off immediately. You can switch all lamps on again by pressing "I" (on). Connecting additional lights to your Philips LivingWhites remote control You can connect other Philips LivingAmbiance/LivingWhites products to your Philips LivingWhites remote control to create immersive lighting scenes. up to 50 products can be connected to one remote. You can connect multiple Philips LivingWhites products (other plugs, energy savers and luminaires) to your remote control. This means that the batteries in the remote control are almost empty and need to be replaced. Does the LivingWhites plug work with luminaires that have a dimmer built in (e. Philips cannot guarantee that the plug will work with another dimmer. Can I connect the LivingWhites plug to a mains socket that is connected to a wall dimmer? No, the plug will not work with a wall dimmer. Do I need to put a special bulb in my luminaire so that it works with the LivingWhites plug? No, the LivingWhites luminaire control plug works with most bulbs (for exceptions, see the next point). Please do not connect a Philips LivingWhites energy saver to the LivingWhites plug, as this might affect your energy saver. Connecting the energy saver to the plug is not necessary, as one of these products is enough to let your luminaire work with a LivingAmbiance/LivingWhites remote control. My question is not listed here · Additional support Service: For your information and in the event of any problem, please visit the Philips website at www. Warranty: The Philips two-year warranty is valid if the product is used in accordance with the instructions and for its intended purpose. [. . . ] To avoid scratching, the LivingWhites plug should only be cleaned with a soft dry cloth. Keep the LivingWhites plug away from liquids and humidity. The LivingWhites luminaire control plug is not a toy designed to be played with by children. For safety reasons and under the terms of the warranty, the LivingWhites luminaire control plug must not be opened. [. . . ]