User manual PHILIPS ACT500/00C

[. . . ] Wear your cd player during sport activity by securing it to the supplied hand strap / waist pack. 1 open the strap enclosure on the back of the hand strap / waist pack and slide the cd player inside. Recharging works only on players supplied with the rechargeable ECO-PLUS NiMH battery AY 3363. recharging the ECO-PLUS NiMH battery on board 1 insert the rechargeable ECO-PLUS NiMH battery AY 3363. [. . . ] Notes: ­ it is normal for the batteries to become warm during recharging. if the batteries become too warm , recharging will be interrupted for approximately 30 minutes and is displayed. ­ to ensure proper recharging on board, take care that contacts are clean. Recharging already charged or half-charged batteries will shorten their lifetime. We therefore recommend that you let the rechargeable ECO-PLUS NiMH battery run till it is completely empty before you recharge it. This set complies with the radio interference requirements of the European Community. The model and serial numbers are located inside the cd door. To avoid a short circuit, do not let the battery touch any metal object. If the battery becomes empty soon after recharging, then either its contacts are dirty or it has reached the end of its lifetime. You can use the following batteries with this cd-player: · alkaline batteries type AAA (LR03 , UM4) or rechargeable ECO-PLUS NiMH battery. Notes: old and new or different types of batteries should not be combined. Remove batteries if they are empty or if the player is not going to be used for a long time. Use only the AY 3170 power adapter supplied with your product (4. 5 V / 300 mA direct current , positive pole to the centre pin). Any other product may damage the player. 1 make sure the local voltage corresponds to the adapter's voltage. 2 connect the adapter to the DC socket of the player and to the wall socket. Note: always disconnect the adapter when you are not using it. 1 put the set on a horizontal , vibration-free and stable surface. Make sure it is in a safe place, where the set is neither a danger nor an obstacle to the driver and the passengers. Plug the voltage converter into the cigarette lighter socket (only for 12 V car battery, negative grounding), then connect the wired end with 4. If necessary, clean the cigarette lighter socket to obtain a good electrical contact. [. . . ] Your set consists of materials which can be recycled if disassembled by a specialized company. Battery indication the approximate power level of your batteries is shown in the display. (on remote control) battery full battery two-thirds full battery one-third full battery dead or empty. When the batteries are dead or empty, the symbol flashes, is displayed, and the beep tone sounds repeatedly. [. . . ]