User manual PHILIPS ACT7585

[. . . ] Switches the set on, starts and interrupts CD play 3 . DIGITAL DYNAMIC BASS BOOST: switches the bass enhancement on and off This button also switches acoustic feedback (the beep) on/off when it is pressed for more than 2 seconds 7 PROG P . Stops CD play, erases a program, activates charging and switches the set off 0 . This set complies with the radio interference requirements of the European Community. [. . . ] Y Playback continues from this position. Notes: ­ If the player is in SCAN mode (see MODE chapter), searching is not possible. ­ In SHUFFLE, SHUFFLE REPEAT ALL or REPEAT mode (see MODE chapter), or while playing a program, searching is only possible within the particular track. You can store up to 30 tracks to play in a program. A single track may be stored more than once in the program. 1 While playback is stopped, select a track with or §. Y PROGRAM lights up; the track number programmed and P with the total number of stored tracks are displayed. You can review the program by pressing PROG P for more than 2 seconds. Notes: ­ If you press PROG P and there is no track selected, SELECt is displayed. ­ If you try to store more than 30 tracks, FULL is displayed. clearing the program · While playback is stopped, press 9 to clear program. Y CLEAr is displayed once, PROGRAM goes off, and the program is cleared. Note: The program will also be cleared if the power supply is interrupted, or if the CD-player lid is opened, or if the set switches off automatically. It is possible to play tracks in random order, to repeat a single track or the entire CD, and to play the first few seconds of each track. 1 Press MODE during playback as often as required in order to activate one of the following `modes'. the active mode is shown in the display. Y SHUFFLE: All tracks of the CD are played in random order until all of them have been played once. y SHUFFLE REPEAT ALL: All tracks of the CD are played repeatedly in random order. Y REPEAT: The current track is played repeatedly. Y REPEAT ALL: The entire CD is played repeatedly. Y SCAN: The first 10 seconds of each of the remaining tracks are played in sequence. 2 Playback starts in the chosen mode after 2 seconds. [. . . ] Do not expose the set, batteries or CDs to humidity, rain, sand or excessive heat (caused by heating equipment or direct sunlight). ⷠYou can clean the CD-player with a soft, slightly dampened, lint-free cloth. Do not use any cleaning agents as they may have a corrosive effect. ⷠTo clean the CD, wipe it in a straight line from the centre towards the edge using a soft, lint-free cloth. [. . . ]