User manual PHILIPS AE5230

[. . . ] Be sure to use your equipment reasonably and take appropriate breaks. Be sure to observe the following guidelines when using your headphones. Listen at reasonable volumes for reasonable periods of time. Be careful not to adjust the volume as your hearing adapts. [. . . ] m DC Jack for the AC adaptor(supplied). E n g l i sh b EN 9 3 Get started Caution Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the back of the apparatus. ___________________________ Place the radio bottom of the unit at back-side. Prepare FM/DAB antenna For optimal reception, fully extend and adjust the position of the FM/DAB antenna. Tip Position the antenna as far away as possible from your TV, VCR or other radiation source to prevent interference. Connect power You can use this radio player on AC power or battery power. hours) When using alkaline R6 (size AA) FM 9 DAB 9 10 EN Option 1: AC power Caution Risk of product damage!Ensure that the power supply voltage corresponds to the voltage printed on the back or the underside of the product. When you unplug the AC adaptor, always pull the plug from the socket. Never pull the cord. Note The type plate is located on the back of the apparatus. 1 Connect one end of the AC adaptor to the DC socket on the main unit. 2 Connect the other end of the AC adaptor to the wall outlet. Option 2: Battery power Caution Do not mix batteries (old and new or carbon and alkaline, etc. ). Remove batteries if they are exhausted or if the unit is not to be used for a long time. 1 2 Open the battery compartment at the back of the unit. Insert 6 R6/UM-3/AA size batteries (not supplied) with correct polarity (+/-) as indicated, then close the battery compartment. EN 11 E n g l i sh 3 The unit is ready to operate. Tip "Battery low" message is shown when the battery power is low. Change batteries to ensure normal operation. Note Batteries contain chemical substances, so they should be disposed of properly. Turn on Press . » The unit switches to the last selected source. To turn off the unit: 1 Press again. 1 Adjust the volume level 1 During play, press VOL+/-to increase/decrease the volume level. 12 EN 4 Listen to FM radio Tune to FM radio 1 2 Press DAB/FMrepeatedly to select FM radio. Press TUNING +/- to tune to a radio station. Search FM radio stations 1 Tune to FM radio. 2 Press and hold TUNING +/- for more than two seconds to start searching stations. » The FM tuner tunes to a station with strong reception automatically. E n g l i sh 3 Store FM stations manually You can program a maximum of 10 preset FM radio stations. 2 To preset number 1 - 5, press and hold the numeric keypad 1 - 5 for two seconds; To select the preset number 6 - 10, press and hold the numeric keypads 5+ simultaneously with other keypad (e. g. 5+ with 1 for 6; 5+ with 5 for 10) for two seconds. [. . . ] Press TUNING +/- to scroll the menu options: [Station list] [System] [DRC] (dynamic range control) [Manual tune] [Full scan] [Local scan] 3 To select an option, press SELECT. 4 Repeat step 2-3 if sub-option is available under one option. [System] [SW version] (Software version of the radio player is shown. ) [Factory reset] (Resets all the settings of this radio player to factory default. ) [Manual tune] the station list. channel/frequency, taking into account the position of the aerial. [. . . ]