User manual PHILIPS AE6360

[. . . ] if the radio is on , it will automatically switch off. ­ It may be necessary to reprogram your preset stations. Poor sound/ no sound: Headphone plug not fully inserted Insert plug fully for personal listening Wrong battery polarity Insert batteries correctly FM antenna (headphone cord) not fully extended Extend FM antenna fully Set too close to TV, computer, etc. Move set away from other electrical equipment Batteries weak Insert fresh batteries Use at high volume can impair your hearing! [. . . ] You can also use the RESET to erase all your radio preset stations. All previous preset stations are erased and the clock time will now need to be re-entered. Press TUNING 3 or 4 (+ or ­) briefly, once or more until the right frequency is found. Press and hold down TUNING 3 or 4 (+ or ­) until the display frequency starts to run. When a station of sufficient strength has been found tuning stops, or you can stop automatic tuning by pressing TUNING 3 or 4 again. Use the tip of a ball-point pen to press the RESET hole and then reprogram settings When you change batteries, the memory protection acts as a backup whereby the time setting, presets and the last FM/AM station listened to are retained for at least 30 minutes. Note: The clock time freezes during memory protection, so you may have to adjust the time after changing batteries. In the rest of the world for example Europe, this step is 9 kHz. Usually the frequency step has been preset in the factory for your area. With a ballpoint pen tip adjust the 9K/10K tuning step switch to select your tuning step. The packaging has been minimized so that it is easy to separate into two materials: card and plastic. In countries where Philips Consumer Electronics Company does not distribute the product, the local Philips service organization will attempt to provide a replacement product (although there may be a delay if the appropriate product is not readily available). Please check your owner's manual before requesting an exchange. Adjustments of the controls discussed there may save you a trip. Or, ship the product, insured and freight prepaid, and with proof of purchase enclosed, to the address listed below. Please record the model and serial numbers found on the product below. Also, please fill out and mail your warranty registration card promptly. It will be easier for us to notify you if necessary. This warranty gives you specific legal rights. You may have other rights which vary from state/province to state/province. This product was designed and manufactured to meet strict quality and safety standards. There are, however, some installation and operation precautions which you should be particularly aware of. [. . . ] Quick stops, excessive force, and uneven surfaces may cause the appliance and cart combination to overturn. Wall or Ceiling Mounting - The appliance should be mounted to a wall or ceiling only as recommended by the manufacturer. Ventilation - The appliance should be situated so that its location or position does not interfere with its proper ventilation. For example, the appliance should not be situated on a bed, sofa, rug, or similar surface that may block the ventilation openings; or, placed in a builtin installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings. [. . . ]