User manual PHILIPS AE6370

[. . . ] Using AC power 1 Check if the power voltage, as shown on the type plate located on the rear of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. Connect the supplied power cord to the AC MAINS (located on the rear panel) and the wall socket. The set is now connected and ready for use. [. . . ] :The symbol indicates that the station is not currently available, or not active. Helpful hints: ­ If there is no DAB coverage currently available, or DAB signal is too weak, in your area, no DAB station will be found, and information like "No station available" will be displayed. If Dim function is activated and there is 15 seconds of button inactivity, the LCD brightness will be decreased to save power. To make new DAB stations and service available on your DAB radio, a search is needed. To not to reset, wait a few seconds until "Press SELECT to confirm reset" disappears. You can preset up to 5 DAB stations on the preset button for easy access. 2 Press PRESET once, and then press 1 / 2 to select preset numbers. Helpful hints: ­ If you have already saved a DAB station in that preset location, it will be overwritten by a new station. ­ When you store DAB stations, these do not overwrite your FM presets. In DAB broadcasting, on the display, the first line shows a station name, and the second line shows the service information for the current station. You are offered with 7 types of information. 2 Press PRESET once, and then press 1 / 2 to select preset numbers. Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnet device shall remain readily operable. Do not expose the set, batteries, CDs to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. the apparatus shall not be exposed to dripping or splashing. Adequate ventilation with a minimum gap of 15cm (6 inches) between the ventilation holes and surrounding surfaces is necessary to prevent heat build-up. ⷠDo not cover the ventilation openings with items such as newspapers, table-cloths, curtains, etc. No objects filled with liquids, such as vases, shall be placed on the apparatus. No naked flame sources, such as lighted candles, should be placed on the apparatus. The mechanical parts of the set contain selflubricating bearings and must not be oiled or lubricated. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing. If a fault occurs, first check the points listed below before taking the set for repair. [. . . ] Do not turn up the volume so high that you can't hear what's around you. You should use caution or temporarily discontinue use in potentially hazardous situations. Do not use headphones while operating a motorized vehicle, cycling, skateboarding, etc. ; it may create a traffic hazard and is illegal in many areas. [. . . ]