User manual PHILIPS AEA7000

[. . . ] •• Never place this apparatus on other electrical •• Keep this apparatus away from direct sunlight, naked •• Ensure that you always have easy access to the power flames or heat. cord, plug or adaptor to disconnect this apparatus from the power. equipment. The 'exclamation mark' calls attention to features for which you should carefully read the supplied literature to prevent operating and maintenance problems. The 'lightening bolt' symbol indicates uninsulated components within the product that can cause an electric shock. [. . . ] The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Philips is under license. Note •• The type plate is located on the back of the unit. 4 EN 2 Your Wireless Microphone and Bluetooth® Speaker Congratulations on your purchase, and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. philips. com/welcome. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the back of the apparatus. ___________________________ • Bluetooth® speaker • 3 X AAA batteries • Quick start guide • Safety sheet English • AC power cord Overview of the unit Wireless microphone b d c Introduction With the Philips wireless microphone and Bluetooth® speaker, you can: • dock your iPad onto the speaker to sing along with music from the app (The Voice: On Stage) through the wireless microphone. With the Bluetooth® speaker, you can: • play music from a Bluetooth® enabled device that supports A2DP (Advanced Audio Distribution Profile). • charge or play music from your iPad directly through the dock connector. • play music from other audio devices through the AUDIO-IN socket. a a Line out socket • (To use the microphone separately) connect to the MIC input socket of an existing Hi-Fi system. b Battery compartment c OFF/ON • Switch the microphone on or off. d Power indicator • Light up red when the wireless microphone is switched on. • Flash red when the battery level is low. Bluetooth® speaker What's in the box Check and identify the contents of your package: • Wireless microphone EN 5 b a c de h gf a • Turn the unit on/off. b Power/Bluetooth® indicator • Indicate the power/Bluetooth® status. d • (Press) pair with a Bluetooth® enabled device that supports A2DP (Advanced Audio Distribution Profile). • (Press and hold) pair with the wireless microphone in case automatic pairing fails. e Dock for iPad f SOFTWARE UPGRADE (not for use by end users) g AUDIO-IN • Connect an external audio player through a 3. 5mm audio input cable (not supplied). h AC MAINS~ • AC power socket. 6 EN Always follow the instructions in this chapter in sequence. Tip •• If the speaker stays idle for more than 15 minutes, it switches to standby mode automatically. Connect power Caution •• Risk of product damage!Make sure that the power supply voltage corresponds to the voltage printed on the back of the unit. When you unplug the AC power cord, always pull the plug from the socket. •• Before you connect the AC power cord, make sure that you have completed all the other connections. Install/replace microphone batteries Caution •• Risk of explosion!Keep batteries away from heat, •• Danger of explosion if batteries are incorrectly sunshine, or fire. [. . . ] •• As a power-saving feature, the speaker switches to standby mode automatically after staying idle for more than 15 minutes. Switch on the speaker again (see 'Switch on the Bluetooth® speaker' on page 7). No power to the wireless microphone •• The batteries may be installed incorrectly or drained. Install or replace the batteries properly (see 'Install/replace microphone batteries' on page 7). [. . . ]