User manual PHILIPS AJ260

[. . . ] The type plate is located on the bottom of the set. Clock and Date When time signal is received, displays. To adjust to your local time If you didn't previously adjust to your local time, or the set is reconnected to power, the time searched by RCC is Central European time. To adjust the time to your local time, you need to calculate the time zone difference between your local time and the central European time, and do the steps described in " Manual setting ". Helpful hints: The searching will stop 10 minutes later if no time signal is received. RCC time will auto be updated at 2: 00 am every day. You don't need to re-adjust to your local time if the set already shows your local time. [. . . ] Press and hold ALM 1/ ALM 2 for two seconds. Hold down or press TUNING +/- repeatedly to adjust the hours. Press ALM 1/ALM 2 to confirm the setting. AL1/AL2 icon and the minute digits flash. Hold down or press TUNING +/- repeatedly to adjust the minutes. Press ALM 1/ALM 2 to confirm the setting. Helpful hints: ­ In standby mode, press DATE to display month and day information. In radio mode, to display alarm time, press ALM 1/ALM 2. 1 2 Selecting alarm mode (activating) Press RADIO ON/OFF to switch to standby. Select your choice of alarm mode: either radio, or buzzer by using the RADIO·BUZ slider. Press ALM 1/ALM 2 once or more to display . At the set alarm time, radio or buzzer will switch on automatically. 3 4 5 6 3 4 ­ 1 3 · Sleep Switching off the alarm There are three ways of switching off the alarm. Unless you choose to cancel the alarm completely, the DAILY ALARM RESET option will be automatically kept activated from the time your alarm first goes off. call at the same time for the following day: Daily alarm reset If you want the alarm to be stopped immediately but also wish to repeat the alarm 1 During the alarm call, press once SLEEP/ALARM RESET or RADIO ON/OFF. Repeat alarm This will repeat your alarm call at 9-minute intervals. During the alarm call, press REPEAT ALARM/BRIGHTNESS CONTROL. Switching off the alarm completely Press once or more corresponding ALM 1 or ALM 2 until disappears. · Weather forecast Weather forecast The unit is capable of detecting atmospheric pressure changes. Based on the collected data, it can predict the weather in the next 12 to 24 hours. The effective range covers an area of approximately 30 to 50 km. Each weather forecast status will be displayed with graphical animation and different lighting colors at the top left hand corner of the unit, see the figure below. About color lighting ­ Battery operation:The light turns on for 10 seconds after each atmospheric measurement, or after any button pressed. ­ AC operation:The light always turns on when the power is switched on. To let the light turn on just like the case of battery operation mentioned above, press and hold REPEAT ALARM/BRIGHTNESS CONTROL for about 10 seconds. LCD display 1 Light color Amber Sleep The clock radio has a built-in sleep timer, which enables the set to be automatically switched off during radio playback after a set period of time. [. . . ] · Extend the pigtail antenna fully. ­ · ­ · ­ · Alarm time not set. Increase the volume. The time searched by RCC is not my local time ­ When the set is reset or power is disconneted/disrupted, RCC time is Central European time. · Adjust the time to your local time. [. . . ]