User manual PHILIPS AJ300DB

[. . . ] SELF-POWERED BACK-UP The self-powered back-up conveniently allows your preset stations, alarm and clock time settings to be stored for up to 10 minutes when there is a power interruption e. g. The complete clock radio and backlight illumination will be switched off. If power supply returns after 10 minutes and the display shows: · clock time blinking - indicates you need to re-adjust the clock time. CAUTION Visible and invisible laser radiation. [. . . ] USING THE ALARM GENERAL Two different alarm times can be set. This can be useful when you need to be woken up at a different time e. g. during the week and at the weekend, and you can set different wake-up modes: · tuner mode. The gentle wake buzzer alarm increases its beep tone frequency within seconds. · dock mode (only for Apple iPod and Philips GoGear SA9100 and SA9200) SETTING THE ALARM TIME (See 3) 1 In any mode, press and hold ALM1 or ALM2 for two seconds. TM ALM1 / ALM2 icon and the hour digits flash. And the icon for the current alarm mode also flashes. 2 Hold down or press ¡1 / 2TM repeatedly to set and adjust the hours. TM ALM1 / ALM2 icon and the minutes digits flash. And the icon for the current alarm mode also flashes. 4 Hold down or press ¡1 / 2TM repeatedly to set and adjust the mintues. SETTING THE ALARM MODE 1 Press POWER to switch to standby mode. 2 Select your choice of alarm mode: either docked player (only for Apple iPod and Philips GoGear SA9100 and SA9200), buzzer, or radio by using the DOCK·BUZZER ·TUNER slider. · At the set alarm time, the docked player (only for Apple iPod and Philips GoGear SA9100 and SA9200) or radio or buzzer will switch on automatically. Helpful hints: ­ If you have selected TUNER alarm mode, make sure you have properly tuned to a station before turning off the set. ­ If you have selected DOCK alarm mode (only for Apple iPod and Philips GoGear SA9100 and SA9200), make sure you have docked the compatible player, or the buzzer mode will be selected automatically. ­ To check the alarm time setting for ALM1 or ALM2, press ALM1 or ALM2. SWITCHING OFF THE ALARM There are three ways of switching off the alarm. Unless you cancel the alarm completely, the 24-hour ALARM RESET will be automatically selected after 59 minutes from the time your alarm first goes off. 24 HOUR ALARM RESET If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day: · Press POWER. REPEAT ALARM This repeats your alarm call at 9 minute intervals. · During the alarm call, press REPEAT ALARM / BRIGHTNESS CONTROL. . TM Display shows ALM1 or ALM2 flashing during a repeat alarm. [. . . ] Notes: ­ In AUX mode, if the AUX-IN cable is not connected for 15 minutes, AJ300D will come to standby. MAINTENANCE & SAFETY · Install the unit near the AC outlet and where the AC power plug can be easily reached. · The apparatus shall not be exposed to dripping or splashing. · Do not expose the set to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. · To clean your set, use a soft damp cloth or chamois leather. [. . . ]