User manual PHILIPS AJ3015

[. . . ] 0 Display ­ shows clock/alarm times and status of the set !Dock connector (30 pins) ­ connects iPod player @ ALM 2 ­ activates/confirm ALARM 2 time setting ­ displays ALARM 2 time ­ switches off ALARM 2 time # REPEAT ALARM / BRIGHTNESS CONTROL ­ switches off the alarm for a 9 minute period ­ changes the brightness of the display illumination $ POWER jack ­ socket for AC/DC 18V adapter % Pigtail ­ improves FM reception ^ ALM 1 ­ activates/confirm ALARM 1 time setting ­ displays ALARM 1 time ­ switches off ALARM 1 time & TIME SET ­ activates/confirm clock time/date setting * (Wake-up mode) DOCK·BUZZER ·TUNER ­ selects alarm mode: dock, buzzer or radio ( AUX IN jack (3. 5 mm) ­ connects to external audio source ) RESET ­ clears clock time setting POWER SUPPLY Mains adapter 1 Connect the mains adapter to the set's DC 18V socket and to the power socket. Helpful hints: To avoid damage to the set, use only the adapter supplied!The type plate is located on the bottom of the set. Remote control Important! [. . . ] TM ALM1 / ALM2 icon and the hour digits flash. And the icon for the current alarm mode also flashes. 2 Hold down or press ¡1 / 2TM repeatedly to set and adjust the hours. TM ALM1 / ALM2 icon and the minutes digits flash. And the icon for the current alarm mode also flashes. 4 Hold down or press ¡1 / 2TM repeatedly to set and adjust the mintues. SETTING THE ALARM MODE 1 Press POWER to switch to standby mode. 2 Select your choice of alarm mode: either docked player, buzzer, or radio by using the DOCK·BUZZER ·TUNER slider. · At the set alarm time, the docked player or radio or buzzer will switch on automatically. Helpful hints: ­ If you have selected TUNER alarm mode, make sure you have properly tuned to a station before turning off the set. ­ If you have selected DOCK alarm mode, make sure you have docked the compatible player, or the buzzer mode will be selected automatically. 3 To cancel sleep, press either: ­ POWER ­ SLEEP once or more until SLEEP disappears from the display. Reset Should your set receive external interference e. g. static electricity from carpets, thunderstorms, etc. RESET allows you to clear all previous settings and start up again. · Use a ballpoint pen to press the RESET hole found on the bottom of the set. ENVIROMENTAL INFORMATION All unnecessary packaging material has been omitted. The packaging can be easily separated into three materials: cardboard, polystyrene and plastic. Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging, dead batteries and old equipment. CONNECTING AN EXTERNAL DEVICE You can listen to the sound of the connected external device through your AJ3015's speakers. 1 Press TUNER/AUX twice to select AUX mode. 2 Use the supplied AUX-IN cable to connect AJ3015's AUX IN jack to an AUDIO OUT or headphone jack on an external equipment (such as CD player, or VCR). MAINTENANCE & SAFETY · Install the unit near the AC outlet and where the AC power plug can be easily reached. [. . . ] In the event of a failure, Philips shall be under no liability for any injury, or any loss or damage caused to property or products other than the product under guarantee. b) Service costs arising from failure to correctly adjust the controls of the product or to observe the instructions, or inspections that reveal that the product is in normal working order. c) Product failures caused by misuse, neglect, accidental breakage, transit damage, inexpert repairs or modification by un-authorised persons, external fires, lightning strikes, floods, vermin infestation or liquid spillage. f) Replacement of worn or used batteries or other consumables. [. . . ]