User manual PHILIPS AJ3040-00P

[. . . ] ⭠to select the alarm mode ­ to select the alarmweekend sleeper mode 7 Socket for AC/DC 7. 5 V adapter 8 Battery compartment 9 REPEAT ALARM ­ to switch off the alarm for a 5 minute period ­ to switch display backlight on/off ­ to switch off slumber 0 24-hour ALARM RESET - to automatically reset the alarm for the same time next day !TUNING - to tune to radio stations @ Display - to show the clock/alarm times and status of the set # BAND - to select FM/MW (LW) waveband $ VOLUME - to adjust the sound level % Pigtail - aerial for FM reception ^ RESET - to reset the clock data SETTING THE TIME & DAY The clock and alarm times and the day need to be entered separately. Setting the clock The time is displayed using the 24 hour clock. [. . . ] 2 As soon as SET TIME is shown, press UP 7 or DOWN 8 to set and adjust both the hours and minutes: ­ with your finger held down on UP 7 or DOWN 8 respectively, the time will increase/decrease rapidly and continuously from minutes to hours. ­ if necessary, press UP 7 or DOWN 8 briefly and repeatedly to adjust the time slowly, minute by minute. 3 Release UP 7 or DOWN 8 when you have reached the correct setting. TM SET TIME goes out after 5 seconds and the clock time is set. Setting the day Setting the day enables you to set the WEEKENDSLEEPER. ) 1 Press ALARM/TIME/DAY SET once or more until the displays shows SET. 2 As soon as the day(s) of the week start to blink, press UP 7 or DOWN 8 briefly and repeatedly until you find the correct day: MON, TUE, WED, THU, FRI, SAT or SUN. TM SET goes out after 5 seconds and the day is set. RADIO You can use this set solely as a radio!The self-powered back-up conveniently allows your day, alarm and clock time settings to be stored for up to 3 minutes when there is a power interruption e. AC power failure or when changing batteries. If you want the radio alarm to wake you up, FIRST CHECK if you have tuned to a station and adjusted the volume loud enough. SWITCHING OFF THE ALARM There are three ways of switching off the alarm. Unless you cancel the alarm completely, the 24-hour ALARM RESET will be automatically selected after 30 minutes, from the time your alarm first goes off. 24-hour alarm reset If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day: · Repeat alarm This will repeat your alarm call at 5-minute intervals up to 5 times. ⷠDuring the alarm call press REPEAT ALARM. Cancelling the alarm To cancel the set alarm before it goes off, or during the alarm call: · Press ALARM MODE/OFF once or more until the active alarm symbol disappears from the display. WEEKENDSLEEPER You can cancel the alarm during the weekend on selective days. There are three options to select from: ­ SAT, SUN: Saturday and Sunday only ­ SUN: Sunday only ­ FRI, SAT: Friday and Saturday only · If you attempt to set the weekendsleeper prior to setting the day, SET and the days of the week will appear to remind you to set the day first. 1 Press WEEKENDSLEEPER MODE· OFF once or more to select your option. TM The days of the week are shown and the weekendsleeper options flash briefly. SLUMBER This set has a built-in timer which enables the set to be automatically switched off during radio playback after a set period of time. [. . . ] There are three slumber times before the set turns itself off: 10, 20 and 30 minutes, off, 10. Setting the Slumber 1 When the radio is on or off, select your slumber time by pressing the SLUMBER button once or more until the desired slumber time is shown e. Press SLUMBER once or more until the radio is switched off. Insert fresh batteries/correctly Display error/no reaction to any controls ­ Electrostatic discharge · press RESET Occasional crackling sound during FM broadcast ­ Weak signal · Extend pigtail fully Continuous crackling/hiss during AM (MW) broadcast ­ Electrical interference from TV, computer, fluorescent lamps, mobile phones, etc. [. . . ]