User manual PHILIPS AJ3040-05B

[. . . ] Helpful hints: To avoid damage to the set, use only the adapter supplied!The type plate is located on the bottom of the set. Remote control Important!· Before using the remote control, remove the insulation plastic tab as shown in the figure. · If the remote control does not function correctly or the operating range is reduced, replace the battery with a new (CR2025) type battery. [. . . ] STORING AND USING PRESET STATIONS You can store up to 5 FM radio stations in the memory. 1 Tune to your desired station (see TUNING TO RADIO STATIONS). 2 To store a preset, hold down briefly on a PRESET button 1-5 until you hear a double beep. TM Display shows the preset number of your station. 3 Repeat steps 1 and 2 to store your other stations. · You can overwrite a preset station by storing another frequency in its place. 4 Press a PRESET button 1-5 (or PRESET 4 / 3 on the remote control) to listen to a preset station. TM To display clock time, press 2; on the set. USING THE ALARM GENERAL Two different alarm times can be set. This can be useful when you need to be woken up at a different time e. g. during the week and at the weekend, and you can set different wake-up modes: · tuner mode. · AJ300D comes with two dock types. Use the designated dock type, as indicated on the top panel of the dock supplied, to work with either Apple iPod or Philips GoGear. COMPATIBLE PORTABLE PLAYER · Most Apple iPod models with 30-pin dock connector as follows: 20GB, 40GB, 20/30GB photo, 40/60GB photo, 30GB video, 60GB video, mini and nano. · Philips GoGear players with dock connectors as follows: - HDD1420, HDD1620, HDD1630, HDD1635; - HDD1820, HDD1830, HDD1835; - HDD1840, 1850; - HDD6320, HDD6330 - SA9100, SA9200 CHANGING THE DOCK The iPod connector is pre-installed with the AJ300D main unit. For Philips GoGear users, change to the supplied Philips GoGear connector before use. 1 Slide the dock switch located near the dock connector to . Then firmly hold down the dock, and simultaneously push the dock switch back to position. DOCK ADAPTERS Before plugging your player in the dock, snap the suitable dock adaptor into the dock to provide a snug fit for the player to be docked. Selecting the correct dock adaptor · For the iPod dock, 8 dock adaptors of different type, as indicated at the back of the adaptor, are included to fit the following iPod: 20GB, 40GB, 20/30GB photo, 40/60GB photo, 30GB video, 60GB video, miniand nano. · For the Philips GoGear dock, 4 dock adaptors of different type are included. Each adaptor is marked a number from "1" to "4" at its back. These numbers indicate the fit Philips GoGear players as follows: "1" = HDD6320/6330 "2" = HDD1420/1620/1630/1635/1820/1830/1835 "3" = HDD1840/1850 "4" = SA9100/SA9200 PLAYING APPLE iPod/PHILIPS GoGear USING AJ300D 1 Snap the compatible iPod/GoGear into the dock connector. [. . . ] 3 To cancel sleep, press either: ­ POWER ­ SLEEP once or more until SLEEP disappears from the display. Reset Should your set receive external interference e. g. static electricity from carpets, thunderstorms, etc. RESET allows you to clear all previous settings and start up again. [. . . ]