User manual PHILIPS AJ3050-00C

[. . . ] When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. 11. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. Battery usage CAUTION ­ To prevent battery leakage which may result in bodily injury, property damage, or damage to the unit: G Install all batteries correctly, + and - as marked on the unit. [. . . ] · When the batteries are turning low, appears in the display. The radio and backlight will not function, but the display and power saving buzzer will continue to operate. · When replacing batteries, the clock time, alarm setting will be stored by the self-powered back-up for 1 minute (see 'Self-Powered Back-Up'). · Make sure the radio is switched off to save battery energy. Batteries contain chemical substances, so they should be disposed of properly. Power adapter 1 Connect the power adapter to the set's DC jack and to the power outlet. TM indicates the set is now adapter operated. · Make sure your adapter is properly connected to save battery energy!2 Always disconnect the power adapter if you are not using the set. NOTE: To avoid damage to the set, use only the adapter supplied!SELF-POWERED BACK-UP The self-powered back-up conveniently allows your alarm and clock time settings to be stored for up to 1 minute when there is a power interruption e. g. AC power failure or when changing batteries. The complete clock radio and backlight illumination will be switched off. As soon as the power supply returns the display will indicate the correct time. · If power supply returns after 1 minute, the demo mode appears and you will need to re-enter all clock settings. BATTERY LOW MODE If you have inserted batteries, the battery low indicator lights up when: · battery power is low. · you intend to use AC power, but the AC adapter connection is loose. During the battery low mode, both Radio/Sleep, backlight and sound will not function. Operation of any set alarm (Radio/Buzzer/Cockcrow) automatically changes to a slow buzzer beep frequency. · If the SLEEP / RADIO ON or BRIGHTNESS CONTROL button is pressed, the battery low indicator will flash for 5 seconds and then remains non-blinking. GENERAL FEATURES Reset Should you receive external interference e. g. static electricity from carpets, thunderstorms, etc. which affects the display and electronic functions of your set, RESET allows you to clear all previous settings and start up again. [. . . ] If you are unable to remedy a problem by following these hints, consult your dealer or service center. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty. Do not open the set as there is a risk of electric shock!No sound ­ Volume not adjusted · Adjust the volume No display backlight / display malfunction/ radio and alarm do not function ­ Set is in Power Low mode · Connect AC/DC adapter or insert fresh batteries Display error / no reaction to any controls ­ Electrostatic discharge · Press the RESET hole on the bottom of the set with a ball-pen. [. . . ]