User manual PHILIPS AJ3121

[. . . ] Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere. How to connect a plug The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L). As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows: · Connect the blue wire to the terminal marked N or coloured black. · Connect the brown wire to the terminal marked L or coloured red. · Do not connect either wire to the earth terminal in the plug, marked E (or e) or coloured green (or green and yellow). [. . . ] 1 Select your choice of alarm mode by adjusting RADIO / ALARM to RADIO or BUZZER. TM The alarm indicator (AL) will light up. Helpful Hint: · If you have selected the radio mode, make sure you have adjusted the volume loud enough to wake you. · The buzzer is set at a fixed volume and cannot be adjusted. SWITCHING OFF THE ALARM There are three ways of switching off the alarm. Unless you cancel the alarm completely, the 24 hour alarm reset option will be automatically selected after 59 minutes, from the time your alarm time first goes off. 24 HOUR ALARM RESET If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day: · Press ALARM RESET during the alarm call. TM The alarm indicator (AL) will remain on. CANCELING THE ALARM COMPLETELY To cancel the set alarm time before it goes off, or during the alarm call: · Adjust RADIO / ALARM to OFF position. TM The alarm indicator (AL) will light off. REPEAT ALARM This repeats your alarm call at 9-minute intervals. 1 During the alarm call, press REPEAT ALARM. 2 Repeat if desired for up to 59 minutes. TM The alarm indicator (AL) will remain on. SLEEP This set has a built-in timer which enables the set to be automatically switched off during radio playback after a set period of time. This allows you to lie back, listen and fall asleep. The maximum sleep time is 1 hour and 59 minutes. Setting SLEEP 1 Set RADIO / ALARM to OFF position. 2 Set the sleep time to activate sleep function by selecting on the following ways: · Simply press SLEEP to set your sleep time to 59 minutes. [. . . ] Problem ­ Possible Cause · Remedy No sound/power ­ Volume not adjusted · Adjust the volume Occasional crackling sound during FM broadcast ­ Weak signal · Adjust the position of the Pigtail Continuous crackling/hiss disturbance during MW broadcast ­ Electrical interference from TV, computer, fluorescent lamp, etc. · Move set away from other electrical equipment The alarm does not function ­ · ­ · ­ · Alarm time not set and or alarm mode not selected Set the alarm time and / select alarm mode Volume too low for RADIO Adjust the volume Radio alarm not adjusted to radio station Tune to a radio station ENVIRONMENTAL INFORMATION We have reduced packaging to the minimum for easy separation into two materials: paper and cardboard. Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe local regulations on the disposal of packing materials and old equipment. [. . . ]