User manual PHILIPS AJ3150-00W

[. . . ] Connect the mains plug into the wall socket. ­ The mains supply is now switched on and the numbers on the display will start to flash. To disconnect the set from the mains completely, withdraw the mains plug from the wall socket. ­ When a power failure occurs, the complete clock radio will be switched off. [. . . ] ­ To retain the clock time and the set alarm time(s) in the event of an power failure or disconnection, you can insert a 9 volt battery (not included), type 6F22, into the battery compartment: should there be a power failure, the clock will continue to function. However, the time will not be illuminated on the clock display, as the use of the battery is strictly to retain both the set clock and alarm time(s) only, where actual operation of the alarm and radio is excluded. As soon as the power is switched on again, the display will indicate the correct time. Before inserting the battery, connect the mains plug to the wall socket. ­ Replace the battery once a year, or as often as necessary. ­ If you do not intend to use the clock radio for a long time, disconnect the set by removing the plug from the wall socket. The battery should also be removed to prevent danger of leakage which will damage your set. ­ To clean your set from fingerprints, dust and dirt, use a clean and soft damp cloth or chamois leather. Do not use cleaning products which contain, benzene, thinner, etc. ­ Avoid exposing the clock radio to rain, dampness and extreme heat to prevent a safety hazard as well as damage to the set. Clock display The time is shown and the display also indicates whether you have switched on the alarm(s), and these indicators will light up respectively next to ALARM 1 and ALARM 2 on the display: 1. ­ If the SLUMBER OFF/REPEAT ALARM button is not pressed again, the alarm will automatically switch off 59 minutes later. Your alarm time setting will then automatically enter the RESET mode and will call at the same time next day. Push the ALARM 1 mode or ALARM 2 mode selector to the OFF position, before or during the set alarm time goes off. The clock radio can awaken you in two ways: Wake by radio: 1. tune to the desired radio station using the TUNING knob. Make sure you have adjusted the volume loud enough to wake you up. This function enables you to listen to the RADIO at bed time without having to get up to switch the radio off. Setting the slumber time The period which you continue to listen to the radio before you fall asleep is called the slumber time. ­ If you press the SLUMBER button once, 59 will appear on the display indicating that you have a slumber time of 59 minutes. ­ If you keep the SLUMBER button pressed, the display will slowly begin to count down from 59 to 00 minutes. Release the button as soon as the required slumber time is reached. [. . . ] Release the button as soon as the required slumber time is reached. Cancelling the slumber time You can switch off the radio before the slumber time has elapsed. ­ If you have an alarm set in the radio mode, make sure you have adjusted the volume loud enough to wake you up before you set the slumber time. If a fault occurs, first check the points listed below before taking the set for repair. [. . . ]