User manual PHILIPS AJ3182

[. . . ] CONTROLS 1 SLEEP - activates the radio for sleep function 2 Clock control - CLOCK : to run on clock time - SET ALARM : sets the alarm time - SET TIME : sets the clock time - HR/MIN : adjusts the hours/ minutes for the clock and alarm times 3 SLEEP OFF /REPEAT ALARM - switches off the radio sleep function - switches off the active alarm for a 8-9 minute period 4 Frequency indicator - shows the radio frequency of your selected waveband 5 TUNING - tunes to radio stations 6 BAND - select FM/MW (AM or LW) waveband 7 VOLUME - adjusts the sound level 8 ALARM RESET - stops the active alarm for 24 hours 9 DISPLAY - show the clock/ alarm times and status of the set 0 RADIO OFF / ON - switches the radio off/on !ALARM ­ OFF switches off the alarm ­ RAD activates the radio for alarm ­ BUZ activates the buzzer for alarm @ Battery door - opens to store a 9 volt 6F22 type battery (not included) for clock memory backup # Mains lead - for AC mains supply $ Pigtail aerial - improves FM reception NOTE: If no backup battery is installed or the power interruption is prolonged, you will need to set the clock and alarm times again. : please follow the instructions on the reverse of this sheet. [. . . ] Unless you cancel the alarm completely, the 24 hour alarm reset option will be automatically selected after 1 hour and 59 minutes, from the time your alarm time first goes off. 24 HOUR ALARM RESET If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day: · press ALARM RESET during the alarm call. CANCELING THE ALARM COMPLETELY To cancel the set alarm time before it goes off, or during the alarm call: · adjust ALARM to OFF position. REPEAT ALARM This repeats your alarm call at 8-9-minute intervals. SLEEP About Sleep This set has a built-in timer which enables the set to be automatically switched off during radio playback after a fixed period of 59 minutes. This allows you to lie back, listen and fall asleep. To adjust the clock and alarm times accurately, always make sure you press the HR or MIN buttons separately and not simultaneously. 1 Turn the clock control to SET TIME or SET ALARM to set the clock or alarm time respectively. Your set consists of materials which can be recycled if disassembled by a specialized company. TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee. Do not open the set as there is a risk of electric shock. This product complies with the radio interference requirements of the European Union. Move set away from other electrical equipment The alarm does not function ­ Alarm time not set and/or alarm mode not selected · Volume too low for RADIO Adjust the volume Radio alarm not adjusted to radio station Tune to a radio station This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: 1 Remove fuse cover and fuse. [. . . ] 2 Fix new fuse which should be a BS1362 5 Amp, A. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. if the mains plug contains a fuse , this should have a value of 5 Amp. [. . . ]