User manual PHILIPS AJ3242

[. . . ] This indicates that you must set the correct time on the clock. ­ To retain the clock time and the set alarm time in the event of a power failure or disconnection, insert a 9 volt battery, type 6F22 (not supplied) into the battery compartment: this will act as a power back up. However, the time will not be illuminated on the clock display. operation of the alarm and radio are also excluded. [. . . ] operation of the alarm and radio are also excluded. For clarity, the battery back up is used to retain the set clock and alarm time (s) only. As soon as the power supply returns, the display will indicate the correct time. Before inserting the battery, connect the mains plug to the wall socket. It is not possible to say precisely how long the battery will last. The service life depends on how often and for how long the power supply fails. This varies according to country and region. Press and hold down the 7 or 4 buttons to set and adjust both the hours and the minutes. ­ With your finger held down on 7, the time will increase rapidly and continuously from minutes to hours. ­ With your finger held down on 4, the time will slowly count down minute by minute. Press SLUMBER OFF/REPEAT ALARM again during the next call if you wish to repeat the alarm call. If, however, you do not press SLUMBER OFF/REPEAT ALARM again, the alarm will sound for 59 minutes before turning itself off. Your alarm time setting will then automatically enter the ALARM RESET mode to sound at the same time next day. cancelling the alarm completely · Before or during the set alarm goes off, push the AL (1 or 2) switch to the OFF position. About SLUMBER time The clock radio has a built-in timer device called the SLUMBER, which enables the radio to be automatically switched off after a set period of time; this allows you to lie back, listen and fall asleep. Keep your finger on the button and the display will begin to count down from 59 to 00 minutes. Release the button as soon as the required slumber time is reached. ­ If during SLUMBER you have turned down the volume and you have an alarm set in radio mode, make sure you have adjusted the volume loud enough to wake you up the next day. ­ If you do not intend to use the clock radio for a long time, disconnect the set by removing the plug from the wall socket. The battery should also be removed to prevent chemical leakage which will damage your set. [. . . ] ­ If you do not intend to use the clock radio for a long time, disconnect the set by removing the plug from the wall socket. The battery should also be removed to prevent chemical leakage which will damage your set. ­ To clean your set from fingerprints, dust and dirt, use a clean and soft damp cloth or chamois leather. Do not use cleaning products which contain benzene, thinner etc. [. . . ]