User manual PHILIPS AJ3290

[. . . ] The mains supply is now switched on and the numbers on the display will start to flash. To disconnect the set from the mains completely, withdraw the mains plug from the wall socket. ­ When a power failure occurs, the complete clock radio will be switched off. [. . . ] General If you wish to use the alarm, then you should first set the alarm time. There is also the choice of two modes for waking you up: by buzzer or radio. Press and hold down the 7 or 4 buttons to set and adjust both the hours and the minutes. ­ With your finger held down on 7, the time will increase rapidly and continuously from minutes to hours. ­ With your finger held down on 4, the time will slowly count down minute by minute. Release the 7 or 4 buttons when you have reached the correct setting. ­ If you have selected the radio mode, make sure you have adjusted the volume loud enough to wake you. ­ The 2 buzzers are at a set volume and cannot be adjusted. BUZ on AL 1 is a low tone buzzer while BUZ on AL 2 is a high tone. You can use this clock solely as a radio. Select your wave band using the BAND switch. To improve radio reception ­ For AM, (MW or LW ) the set is provided with a built-in aerial which to function best should be placed on a non-metallic surface e. ­ For FM , extend the pigtail wire at the back of the set completely for optimum reception. You can switch off the alarm in three ways: Unless you choose to cancel the alarm completely, the ALARM RESET option will be automatically selected after 59 minutes from the time your alarm first goes off. [. . . ] ­ If you are unable to remedy a problem by following the hints below, consult your dealer or service centre. WARNING: under no circumstances should you try to repair the set yourself, as this will Rotate the set for better reception and make sure the set is placed on a non-metallic surface. We have tried to make the packaging easy to separate into three mono-materials: cardboard (box), polysterene (buffer) and polyethylene (bags). [. . . ]