User manual PHILIPS AJ3470

[. . . ] ) · If does not appear or blinks for more than 3 seconds, this means that the radio controlled clock transmission is too weak to be received, and you will need to set the clock manually to run on normal quartz time. ⷠWhen the radio time transmission for your time zone is duly received, this information will replace any manually set time. to improve radio controlled clock reception: 1. [. . . ] Alarm time display If you have set both alarms, the standby alarm time display will show the alarm time which is ready to go off first 1, according to the current clock time. If current clock time = 7:30 AL = 6:20 AL = 7:45, then the standby alarm display shows the alarm time, 7:45 1. SWITCHING OFF THE ALARM There are three ways of switching off the alarm. Unless you cancel the alarm completely, the ALARM RESET option will be automatically selected after 59 minutes, from the time your alarm time first sounds. Note: During an alarm call/ repeat alarm, only the ALARM RESET/ RADIO OFF, REPEAT ALARM/ BRIGHTNESS or AL controls on the set CONTROL and AL will operate. ALARM RESET If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day: · press DAILY ALARM RESET/ OFF =You will hear a long beep tone to confirm that the alarm reset has been activated. REPEAT ALARM This will repeat your alarm call at 9-minute intervals. ⷠDuring the alarm call, press REPEAT ALARM/ =The radio frequency and waveband appears in the display for 10 seconds before reverting back to the clock display. Tune to your station manually or automatically by using 3 / 4 (up / down). Repeat until you have found the desired station. Press and hold 3 / 4 until the display frequency starts to change frequency. When a station of sufficient strength has been found, tuning will stop, or you can stop the automatic tuning search by pressing either 3 / 4 again. Repeat until you have found the desired station. PRESET STATIONS (see figure 5) Storing preset stations You can program up to five radio stations for each band. If you like, you can also replace a preset station with another frequency. The current station will be indicated by a square round the preset number in the display. [. . . ] If you are unable to remedy a problem by following these hints, consult your dealer or service centre. TROUBLESHOOTING Continuous crackling/ hiss disturbance during MW broadcast ­ Electrical interference from TVs, computers, fluorescent lamps, etc. ⷠMove set away from other electrical equipment The alarm does not function ­ · ⭠· Alarm time not set Set the alarm time Alarm mode not activated Press AL or AL once or more until the display shows ON. [. . . ]