User manual PHILIPS AJ-3551

[. . . ] Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. may result in bodily injury, property damage, or damage to the unit: Install all batteries correctly, + and - as marked on the unit. Do not mix batteries (old and new or carbon and alkaline, etc. ). Remove batteries when the unit is not used for a long time. n Battery usage CAUTION ­ To prevent battery leakage which · · · o Apparatus shall not be exposed to dripping or splashing. [. . . ] To fully benefit from the support that Philips offers, register your product at www. philips. com/welcome. Introduction With this unit, you can: · listen to the radio · know the time · set alarm timer to wake you up at certain time. What's in the box Check and identify the contents of your package: · Main unit · User manual Overview of the main unit (See 1) a SET ALARM/CLOCK/SET TIME · · · · · Set the alarm timer/time. Show current status. b HOUR c MINUTE d Display panel e REPEAT ALARM/BRIGHTNESS CONTROL · · · · · · · · · · · · Repeat the alarm. Adjust volume. f AUTOSCAN g SLEEP/ALARM RESET h BUZZER/RADIO ALARM i MW/FM j - PRESET + k ALARM ON/OFF l RADIO ON/OFF m TUNING +/- n VOL +/- 3 Get started Caution · Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the apparatus. ___________________________ Install batteries Note · You can only use AC power as power supply. Batteries (not supplied) are for backup purpose. 1 2 3 Open the battery compartment. Insert 4 x 1. 5V R03/UM-4/AAA batteries with correct polarity (+/-) as indicated. Close the battery compartment. Connect power Caution · Risk of product damage!Ensure that the power voltage corresponds to the voltage printed on the back or underside of the apparatus. When you unplug the AC adaptor, always pull the plug from the socket. · Before connecting the AC adaptor, ensure you have completed all other connections. Note · The type plate is located on the bottom of the main unit. 1 Plug the AC power cord to the wall socket. Set clock 1 2 3 4 In standby mode, rotate SET ALARM/CLOCK/SET TIME to the SET TIME position. » The hour and minute digits begin to blink. Rotate the SET ALARM/CLOCK/SET TIME to the CLOCK position to confirm. Adjust volume level 1 During play, turn VOL +/- to increase/decrease the volume level. 4 Listen to radio Tip Tune to a radio station · Position the antenna as far as possible from TV, VCR or · For optimal reception, fully extend and adjust the position of the antenna. other radiation source. 1 2 3 4 · Press RADIO ON/OFF to turn on the radio. Press and hold TUNING +/- for more than 2 seconds. » The radio tunes to a station with strong reception automatically. To tune to a weak station, press TUNING +/- repeatedly until you find optimal reception. Program radio stations automatically You can program a maximum of 20 preset radio stations. 1 In the tuner mode, press and hold AUTOSCAN for more than 2 seconds to activate automatic program mode. » All available stations are programmed in the order of waveband reception strength. » The first programmed radio station is broadcast automatically. Program radio stations manually You can program a maximum of 20 preset radio stations. [. . . ] When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. No power · Ensure that the AC power plug of the unit is connected properly. · Ensure that there is power at the AC outlet. No response from the unit · Disconnect and reconnect the AC power plug, then turn on the unit again. [. . . ]